Uline H-88 Manual De Instrucciones

π
H-88
INDUSTRIAL HANDWRAPPER
Figure 1
TO LOAD FILM ONTO HANDWRAPPER
NOTE: Handwrapper comes preset at 12" height.
Must unthread completely to use larger rolls.
1. Unscrew the top knob (turn counterclockwise) about
1/2 inch. Remove the slotted top core holder by sliding
it out of the threaded rod section. (See Figure 1)
2. Slide the film roll over the top knob and position the
film core over the bottom core holder.
3. Take the top core holder and slide it back through
the threaded rod section. Drop it into the top of the
core.
4. Screw the top knob clockwise until it holds the top
core holder in place.
PAGE 1 OF 3
LOADING AND UNLOADING INSTRUCTIONS
Top Knob
Threaded Rod Section
1-800-295-5510
uline.com
Knob Assembly
(Washer, Bearing,
Threaded Rod)
Top Core Holder
Bottom Core Holder
TO REMOVE FILM FROM HANDWRAPPER
1. Unscrew the top knob (turn counterclockwise) about
1/2 inch. Remove the slotted top core holder by sliding
it out of the threaded rod section. (See Figure 1)
2. Remove the film by sliding it over the top knob.
Para Español, vea página 2.
Pour le français, consulter la page 3.
0421 IH-88