Section 1. Getting Started; What Is Included; Ac Power; Safety Instructions - TECshow ALFIE Mini moving head – 4 x Osram 10W RGBW LEDs Manual De Usuario

Tabla de contenido

Publicidad

Section 1. Getting Started

What is included

- 1pc Mini wash
- 1pc User Manual
Unpacking
Thanks for using our ALFIE mini moving beam. Immediately upon
receiving a fixture, carefully unpack the carton, check the contents
to ensure that all parts are present, and have been received in
good condition. Notify the shipper immediately and retain packing
material for inspection if any parts appear damaged from shipping
or the carton itself shows signs of mishandling. Save the carton
and all packing materials. In the event that a fixture must be
returned to the factory, it is important that the fixture be returned
in the original factory box and packing.

AC Power

This fixture use a switch power supply, it can transform by
itself when user input power!

Safety Instructions

- Please keep this User Guide for future consultation. If you sell the
unit to another user, be sure that they also receive this instruction
booklet.
- Always make sure that you are connecting to the proper voltage,
and that the line voltage you are connecting to is not higher than that
stated on the decal or rear panel of the fixture.
- This product is intended for indoor use only!
- To prevent risk of fire or shock, do not expose fixture to rain or
moisture. Make sure there are no flammable materials close to the
unit while operating.
- The unit must be installed in a location with adequate ventilation, at
least 20in (50cm) from adjacent surfaces. Be sure that no ventilation
slots are blocked.
- Always disconnect from power source before servicing or replacing fuse
and be sure to replace with same fuse size and type.
- Secure fixture to fastening device using a safety chain. Never carry
the fixture solely by its head. Use its carrying handles.
- Maximum ambient temperature (Ta) is 104ºF (40ºC). Do not operate
fixture at temperatures higher than this.
- In the event of a serious operating problem, stop using the unit
immediately. Never try to repair the unit by yourself. Repairs carried
out by unskilled people can lead to damage or malfunction. Please
contact the nearest authorized technical assistance center. Always
use the same type spare parts.
- Don t connect the device to a dimmer pack.
- Make sure the power cord is never crimped or damaged.
- Never disconnect the power cord by pulling or tugging on the cord.
- Avoid direct eye exposure to the light source while it is on.
1ra. Sección. Empezando
Que se incluye
- 1 Mini wash
- 1 Manual de usuario
Desempaque
Gracias por usar nuestro mini moving head ALFIE. Inmediatamente
después de recibir este equipo, desempáquelo cuidadosamente y
chequee el contenido para asegurarse que todas las partes estén
presentes y en buenas condiciones. En caso de que alguna de las
partes del equipo se presenten dañadas o la caja presente signos
de maltrato durante su transporte, notifique de inmediato al
distribuidor. Guarde el cartón y el embalaje. En el caso de que el
equipo deba ser devuelto a fábrica, es importante que el mismo
esté en su empaque original.
Energía y conectores
Este equipo utiliza una entrada de energía por switch.
Instrucciones de seguridad
- Por favor, guarde estas Instrucciones de seguridad para consultar
a futuro. Si vende este equipo a otro usuario, asegúrese que reciba
está guia con el equipo.
- Asegúrese siempre que el equipo este conectando al voltaje correcto
y que la línea de voltaje a la que se esté conectando no sea superior a
la detallada en la placa trasera del producto.
- Este producto está diseñado para uso en interiores solamente.
- Para prevenir riesgo de incendio, no exponga el equipo a la lluvia
o lugares húmedos. Asegúrese que no haya materiales inflamables
cerca de la unidad mientras esta opera.
- La unidad debe instalarse en un lugar con buena ventilación, por lo
menos a 50cm de superficies adyacentes. Asegúrese que las ranuras
de ventilación no estén bloqueadas.
- Desconecte siempre el cable de energía antes de remplazar un fusible
o realizar cualquier tipo de mantenimiento al equipo. Asegúrese
al cambiar de fusible que el repuesto sea del mismo tipo y tamaño.
Siempre levante el equipo por sus asas.
- La temperatura ambiente máxima es 40ºC. No opere el equipo a
temperaturas más altas que estas.
- En el caso de un problema serio al operar, deje de utilizar la unidad
inmediatamente. Nunca trate de reparar la unidad usted mismo.
Reparaciones llevadas a cabo por personal inexperto pueden llevar a daños
mayores o mal funcionamiento. Por favor contacte al personal autorizado
más cercano. Utilize siempre los mismos repuestos.
- No conecte el equipo a un dimmer pack.
- Asegúrese que el cable de energia no esté dañado.
- Nunca desconecte el cable de energía tirando del mismo.
- Evite contacto visual directo con la fuente de luz encendida.

Publicidad

Tabla de contenido
loading

Tabla de contenido