Roland KSC-40 Manual De Instrucciones

- Make sure that another person is on hand to help with the assembly and setup.
- Be very careful, when you assemble and move the piano, to make sure that you do not drop it on your
hands or feet.
- To move the piano, lift it carefully—all the while keeping it level.
- Be sure to keep any screws, caps, and other small components out of the reach of small children so as to
prevent any child from accidentally swallowing these items.
- Do not use a power tool (e.g., an electric screwdriver) to assemble the stand. You risk damaging or
stripping the screws.
■ Parts Check
Before you begin assembling the stand, check that all the parts
were supplied. You will also need to have a Phillips screwdriver.
KSC-42
A: Side Board (left)
B: Side Board (right)
C: Pedal Board
D: Rear Board
■ Assembly Procedure
* Fasten each screw tightly, then place the stand in a stable and horizontal place.
Also, carry out assembly of the instrument on an even surface.
* Do not allow the pedal cord or power cable to get twisted or pinched while
assembling the stand.
* Do not set up the instrument on long-piled carpeting. This can cause instability
in the stand and unsteadiness in the pedals, possibly resulting in damage to the
unit.
* Lay a soft cloth or similar material on the floor, and assemble the stand atop this
surface.
* When tightening the screws, turn them two or three revolutions by hand before
using a screwdriver.
Stand Assembly
At first, assemble the entire stand in a temporary fashion, without really
tightening the screws. Then, after checking the overall alignment of the
boards (and gently shifting certain parts where necessary), go around
and tightly fasten each of the screws.
1.
Attach the side boards for the right and left sides to the
pedal board (so that the metal parts face inside) using
screws "a" (M5 x 40 mm).
Screw "a" 2pcs
Screw "a" 2pcs
* When attaching the pedalboard, do not allow any gap to remain between the side
board and pedalboard when the pieces are assembled.
Improper
Side board
Space
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
1
KSC-40/42
1: Screw "a" (M5 x 40 mm) x4
2: Screw "b" (M5 x 20 mm) x6
1
Correct
Side board
Pedal board
Copyright © 2007 ROLAND CORPORATION
STAND ASSEMBLY
2.
Loosen the screws attached to the left and right side
boards approximately three turns, so that they protrude
about 3mm, as shown in the illustration.
3.
Hook the metal brackets of the rear board over the screws
you loosened (c), as shown in the illustration.
4.
Use four screws "b" (M5 x 20mm) to provisionally fasten
the pedal board.
5.
Securely tighten the two side board screws and four pedal
board screws.
When attaching the rear board, before tightening the screws, adjust
things as necessary at all the points where there are screws so as to assure
that the rear board is aligned in parallel with the pedal board.
4, 5
Screw "b" (4 pieces)
Pedal
board
2
Rear view
3
5
Screws you loosened
in step 2 (2 screws)