Technical Specifications - Black And Decker Bxae00022 Manual Del Usuario

Suitable for charging WET or GEL batteries.
6.
Charging current for batteries: from 30Ah to 80Ah.
Maintenance mode for batteries: from 30Ah to 120Ah.
Suitable for charging WET or GEL batteries.
7. Mode for charging AGM-START&STOP and AGM-SPIRAL batteries.
8.
Charge LED indicator (orange).
9.
Full LED: lightening up green when fully charged.
10.
Reverse polarity LED (red).
11. Fault LED: lightening up when there is an issue with the battery (red).
12. Output lead: Cable with clamps 30A - Ref: BXAE00025.
13.
Output lead: Cable with rings 6mm and protective, insulating, watertight
cap.

2.1. Technical specifications

Reference
Model
Voltage (Mains)
Charging voltage
Charging current
Battery size
Operating temperature
Storage temperature
IP indication
Minimum battery voltage
2.2. Battery types
This electronic battery charger is designed to charge all types of lead batteries,
conventional batteries and batteries of the latest generation. This battery charger
is ideal for both everyday use, as a key working tool, and extensive charging cycles.
All charging parameters are set using the charge function key on the control panel.
2.3. Charge cycles
The charge cycles of the battery charger have been specially developed to optimize
the charge of all types of batteries currently available in the market. The numerous
constructional technologies of currently available batteries require different
charging curves to ensure correct and complete charging. This battery charger
extends the lives of your batteries because it provides each with the proper charge
cycle.
2.4. Interruption of the charge cycle
In case of blackouts in the 230V mains, the battery charger saves the work cycle it
was performing in order to restore it automatically as soon as the power supply of
the 230V mains is restored. This function is crucially important if the battery charger
is used to charge batteries without the operator supervising the cycle; for example,
during very long work cycles (maintenance charges) or when charging overnight
(charges for vehicles that need to be charged daily). The set parameters are stored
for 12 hours; after 12 hours the battery charger will resume charging with the default
parameters.
BXAE00022
Charger 6/12V-4A
220~240V AC 50/60Hz
6V / 12V
1A / 4A
4Ah to 120Ah batteries
-10° to +40°C
-20° to +50°C
IP65
0,8V
5