Cooper TR11 Instrucciones De Instalación

IB519021EN
Installation Instructions - TR11 LED
Instructions d'installation - DEL TR11
Instrucciones de instalación - LED TR11
WARNING
Make certain power is OFF before starting installation
or attempting any maintenance. Risk of fire/electric
shock. If not qualified, consult an electrician.
RISK OF ELECTRIC SHOCK— Disconnect power
● ●
at fuse or circuit breaker before installing or
servicing.
RISK OF BURN—Disconnect power and allow
● ●
fixture to cool before servicing.
IMPORTANT: Read before installing fixture. Retain for future reference.
GENERAL: Upon receipt of fixture thoroughly inspect for any freight damage, which should be brought to the attention
of the delivery carrier. Compare the catalog description listed on the packing slip with the fixture label on the housing to
assure you have received the correct merchandise.
SAFETY: This fixture must be wired in accordance with the National Electrical Code and applicable local codes and
ordinances. Proper grounding is required to insure personal safety. Carefully observe grounding procedure under
installation section.
CLEANING: The reflector and lens may be cleaned with any non-abrasive cloth and mild detergent (i.e. 409 Cleaner).
Cleaning should be done on the lens at room temperature, and out of direct sunlight. To remove paint, lipstick, marker,
etc., the following solvents may be used.
RECOMMENDED:
1. A solution of three (3) parts alcohol, one (1) part TOLUOL.
2. Four (4) parts alcohol, one (1) part Methylethylketone MEK). Also safe, but less effective: Naphtha, Butyl Celiosolve,
Kerosene.
RISK OF PERSONAL INJURY— Fixture may
● ●
become damaged and/or unstable if not installed
properly.
NOTICE: These instructions do not claim to cover all
details or variations in the equipment, procedure, or
process described, or to provide directions for meeting
every possible contingency during installation, operation
or maintenance. When additional information is desired
to satisfy a problem not covered sufficiently for user's
purpose, please contact your nearest representative.
Design specifications and dimensions are subject to
change without notice.
OR
Brand Logo
reversed out of
black
INS # INS #