koban KDP7 180 Manual De Instrucciones

KDP7 180
0775871
Instruction
Welcome to use ST10F Infrared motion sensor!
The product adopts good sensitivity detector and integrated circuit. It gathers automatism,
convenience, safety, saving-energy and practical functions. It utilizes the infrared energy from
human as control-signal source and it can start the load at once when one enters detection
field. It can identify day and night automatically. It is easy to install and used widely.
SPECIFICATION:
Power Source: 220-240V/AC
Power Frequency: 50/60Hz
Ambient Light: <3-2000LUX (adjustable)
Time Delay: Min.10sec±3sec
Max.7min±2min
Rated Load: Max.1200W
300W
FUNCTION :
➢
Can identify day and night: The consumer can adjust working state in different ambient
light. It can work in the daytime and at night when it is adjusted on the "sun" position (max).
It can work in the ambient light less than 3LUX when it is adjusted on the "moon" position
(min). As for the adjustment pattern, please refer to the testing pattern.
➢
SENS adjustable: It can be adjusted according to using location. The detection distance
of low sensitivity could be only 5m and high sensitivity could be 12m which fits for large
room.
➢
Time-Delay is added continually: When it receives the second induction signals within the
first induction, it will restart to time from the moment.
Good sensitivity
INSTALLATION ADVICE:
As the detector responds to changes in temperature, avoid the following situations:
➢
Avoid pointing the detector towards objects with highly reflective surfaces, such as mirrors
etc.
➢
Avoid mounting the detector near heat sources, such as heating vents, air conditioning
units, light etc.
Detection Range: 180°
Detection Distance: 5-12m (<24℃) adjustable
Working Temperature: -20~+40℃
Working Humidity: <93%RH
Power Consumption: approx 0.5W
Installation Height: 1.8-2.5m
Detection Moving Speed: 0.6-1.5m/s
Poor sensitivity