GEA CGY366 Manual De Instrucciones

PROPANE CONVERSION INSTRUCTIONS
WARNING
Explosion Hazard
Death or serious injury can result from failure to follow these
instructions.
replaced for propane.
WARNING
and toxic fumes which can result in serious injury.
TOOLS REQUIRED:
• •
• Socket wrench with or 7mm
• 7mm open end wrench
• •
• •
instructions:
CONVERTING THE PRESSURE
REGULATOR
Oven Regulator
Rotate cap counter-
clockwise to loosen
the pressure regulator.
threaded metal cap.
(Do not over tighten)
Cooktop Regulator
from the pressure regulator.
propane gas and reinstall
into the regulator.
CONVERTING THE COOKTOP BURNERS
Burner cap
Burner cap
Burner head
located
through this
opening
Base
Base
Multi-ring Round burner
Cooktop
Regulator
Propane
Kit
NOTICE:
95
NAT
III
BURNER OUTPUT RATINGS: BTU/HR
Propane Gas 10" W.C.P.
BTU RATE
BURNER
PROPANE
LF
C N/A
C1 N/A
N/A
C3 N/A
RF
Natural Gas
Position
Propane
Position
C1 C2
C
C3
Burner cap
Burner head
CONVERT GRIDDLE ORIFICE
located
through this
(Models C2Y486 and CGU486 only)
opening
Base
Inspiral Burner
clamping screws.
Clamping Screws
B. Lift out the cast-iron grease trough.
Denotes 0.95mm Orifice size opening
Denotes LP (Propane)
toward the rear and out of the hold-
ORIFICE SIZE MARKING
and capillary aside.
89L
gas inlet.
entry hole. Place the unused
Griddle
LR CR RR
future use.
LF CF RF
Para acceder a instrucciones completas en Espa-
NOTE:
on the inside only.
outermost screws—
Hold-Down
Burner
Capillary
Screws
Bracket
Capillary
Capillary
Bracket
Screws
Front of Range
GEAppliances.com.
PROPANE CONVERSION INSTRUCTIONS
31-2000802 Rev. 5 05-21 GEA
CGY366, C2Y366, C2Y486, CGU366, CGU486