Installation Instructions - INTIRION Micro fridge 2.5MF4RE Manual Del Propietário

INSTALLATION INSTRUCTIONS

LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example in a wet basement or near a sink.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 49.8 cm (19.6 inches) wide
by 68.3 cm (26.9 inches) high by 44.8 cm
(17.7 inches) deep. Make sure that you leave
the minimum amount of space between the
appliance and all surrounding walls and vents.
• Allow 12.7 cm (5 inches) of space between the
back of the appliance and the wall. Allow 5
cm (2 inches) between the sides and top of the
appliance and any walls or counter tops.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
BRACKET & MICROWAVE INSTALLATION
Place the brackets on top of the refrigerator and the
microwave on the brackets as per the image below.
Secure with the screws provided in the accessory
bag.
• Do not block the inlet and outlet openings
located at the rear and bottom of the
microwave.
• Do not remove the feet from the bottom of the
microwave.
Plug the refrigerator into the socket in the rear of
the microwave. This socket is only approved for use
with MicroFridge® with Safe Plug® refrigerators.
Do not use this socket with any other appliance.
Plug the microwave into a standard 115 V
household outlet. Ensure no other appliance is
plugged into the same outlet.
The combination appliance will operate with 11 -
15 amps of current draw.
Note: The MicroFridge® with Safe Plug® dual
outlet charging stations will not operate while
the microwave is running. This patent-pending
technology prevents wiring overload.
2