Yamaha RX-V577 Guia De Conexion A Red Inalambrica

Wireless network connection guide
This document explains how to connect the unit to a wireless network.
Attaching the wireless antenna
Attach the supplied wireless antenna to the unit.
Be sure to turn off the unit before attaching the antenna.
Screw in
Bend
Turn clockwise to the vertical position
ES S
W IR EL
Joint
ES S
W IR EL
ES S
W IR EL
• Do not apply excessive force on the antenna. Doing so may damage the antenna.
• When attaching the antenna, hold the root of the antenna and screw it into the WIRELESS jack tightly.
• The antenna can be bent in only one direction. Check the orientation of the joint and bend the antenna in
the proper direction.
• Do not connect the antenna other than the supplied one.
• When packing the unit, remove the antenna to prevent damage.
Connecting the unit to a wireless network
Connect the unit to a wireless router (access point).
There are several methods to connect the unit to a wireless network. This section
describes the following three methods.
A: Using the WPS button configuration
Set up a wireless connection with the WPS button on the wireless router
(access point).
B: Sharing the iOS device setting
Set up a wireless connection by applying the connection settings on iOS
devices (iPhone/iPod touch*).
* You need iOS devices with iOS 5.0 or later.
C: Searching for an access point
Set up a wireless connection by searching available access points.
• Manual configuration is also available. For details, see "Connecting to a network wirelessly" on the Owner's
Manual.
English
1