Idiomas disponibles

Idiomas disponibles

iMpOrtaNt:
NOtE: DO NOt rEtUrN UNit tO tHE StOrE
BEFOrE cONtactiNG OUr cUStOMEr SErVicE
DEpartMENt. DO NOt DiSpOSE OF yOUr
cartONS UNtil yOU arE cOMplEtEly SatiSFiED
witH yOUr NEw FirEplacE HEatEr.
plEaSE NOtE: wHEN yOU OpEN tHE cartON carEFUlly cHEck
tHE UNit aND MakE SUrE tHErE iS NO DaMaGE. iF yOU HaVE
aNy prOBlEMS witH aSSEMBliNG tHE UNit, witH HOw tHE
VariOUS FUNctiONS wOrk Or witH DaMaGE Or MiSSiNG partS,
plEaSE GO tO OUr wEBSitE www.qUalitycraFt.cOM aND
click ON cUStOMEr SUppOrt.
NOtE: light bulbs may become loose during shipping. if the flame effect is dim or does not
work, please check that light bulb or bulbs are finger tight in socket. See instructions for
replacing bulb or bulbs.
NOtE: the electric fireplace heater may emit a slight harmless odor when first turned on. this
is caused by activating the internal heater components for the first time and should not occur
again.
INSTRUCTION MANUAL
attENtiON:
1. Find a location for the fireplace heater that is protected from direct sunlight.
2. Do not plug the unit into the power outlet before reading all instructions.
IMPORTANT SAFETY
INSTRUCTIONS
wHEN USiNG ElEctrical appliaNcES, BaSic prEcaUtiONS SHOUlD alwayS BE
FOllOwED tO rEDUcE tHE riSk OF FirE, ElEctric SHOck, aND iNJUry tO pErSONS,
iNclUDiNG tHE FOllOwiNG:
1) read all instructions before using this electric fireplace heater.
2) this electric fireplace heater is hot when in use. to avoid burns, do not let bare skin touch
hot surfaces. the grill directly in front of the heater outlet becomes hot during heater
operation. keep combustible materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3 ft (0.9 m) away from the front of the unit and keep them
away from the sides and rear.
3) Extreme caution is necessary when any heater is used by or near children or individuals
with disabilities and whenever the fireplace is left operating and unattended.
4) always unplug fireplace when not in use.
5) Do not operate any electric fireplace with a damaged cord or plug or after the heater
malfunctions, has been dropped or damaged in any manner.
ElEctric FirEplacE HEatEr
Model: M405-48FBK
6) Do not use outdoors.
7) this electric fireplace heater is not intended for use in bathrooms, laundry areas and
similar indoor locations. Never locate heater where it may fall into a bathtub or other
water container.
8) Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar
coverings. arrange cord away from traffic area and where it will not be tripped over.
9) to disconnect fireplace, turn controls to off, then remove plug from outlet.
10) connect to properly grounded outlets only.
11) Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this
may cause an electric shock or fire, or damage the heater.
12) to prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on
soft surfaces, like a bed, where openings may become blocked.
13) a heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline,
paint, or flammable liquids are used or stored.
14) Use this fireplace heater only as described in this manual. any other use not
recommended by the manufacturer may cause fire, electric shock, or injury to persons.
15) avoid the use of an extension cord because the extension cord may overheat and cause
a risk of fire. However, if you have to use an extension cord, the cord shall be No.14 awG
minimum size and rated not less than 1875 watts.
16) caution: Do not plug this product into a receptacle controlled by a wall switch or dimmer.
17) when storing or transporting the unit and cord, keep in a dry place, free from excessive
vibration and store so as to avoid damage.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE.
caUtiON:
iF yOU USE tHiS HEatEr iN cONJUNctiON witH a tHErMal cONtrOl, a prOGraM
cONtrOllEr, a tiMEr Or aNy OtHEr DEVicE tHat SwitcHES tHE HEatEr ON
aUtOMatically, rEMEMBEr tO OBSErVE all SaFEty warNiNGS at all tiMES. tHE
FirEplacE HEatEr HaS SaFEty OVErHEat prOtEctiON. iF tHE OVErHEat prOtEctiON
tripS, SwitcH OFF all SwitcH BUttONS aND wait apprOxiMatEly 5 - 10 MiNUtES. it
SHOUlD rESEt aUtOMatically ONcE tHE UNit cOOlS DOwN.
warNiNG - DO NOt lOaD MOrE tHaN 22.7 kG (50 lBS) ON tHE tOp SHElF.
warNiNG: prOcEDUrES aND tEcHNiqUES iF NOt carEFUlly FOllOwED will rESUlt iN
DaMaGE tO tHE EqUipMENt aND will ExpOSE tHE USEr tO tHE riSk OF SEriOUS iNJUry,
illNESS Or DEatH.
A 15 AMP circuit is required to operate this heater. If the breaker trips when the heater
is used, then you may need to move the heater to another location or unplug other
appliances that are on the same circuit. If you require an extension cord use one that is
rated at 1875 watts.
1
Tabla de contenido
loading

Resumen de contenidos para decorflame M405-48FBK

  • Página 16: Calefactor Eléctrico

    ElÉctricO Modelo: M405-48FBK iMpOrtaNtE: 5) No haga funcionar ninguna chimenea que tenga un cordón o enchufe dañado o después de que haya funcionado mal, se haya caído o dañado. NOta: NO DEVUElVa la UNiDaD a la tiENDa 6) No utilice la chimenea al aire libre.
  • Página 17 aDVErtENcia: Y) JUEGO PARA AUTORREPARACIONES Pintura para efectuar retoques (botella) .............. 1 Si no se siguen atentamente los procedi-mientos y técnicas indicados, se dañará el Soporte en forma de “L” ..................2 equipo; el usuario quedará expuesto al riesgo de sufrir lesiones o dolencias graves o Tornillos para el soporte en forma de “L”...
  • Página 18 Paso 1: Sujete los 36 conectores plásticos [X] a los paneles G, H, I. J, Da, Dd, Dc, y Dd con Paso 4: Sujete los paneles G, H, I y J al panel D con 8 tornillos largos [W]. Vea la fig. D. 72 tornillos largos [W] (2 tornillos para cada conector).
  • Página 19 Paso 7: Sujete el panel C a los paneles G, H, I y J con 8 tornillos largos [W], como se Paso 9: Sujete el panel A a los paneles G y H con 4 tornillos largos [W], como se muestra muestra en la fig.
  • Página 20 Paso 12: Sujete las bisagras de la puerta [Q] a la puerta izquierda [M] y a la puerta Paso 16: Procure que la cinta de espuma cubra completamente ambos rebordes laterales, derecha [N] con 8 tornillos de montaje [T] (2 tornillos para cada bisagra). Sujete como se muestra en la fig.
  • Página 21 OPERACIÓN REEMPLAZO DE LAS BOMBILLAS Paso 1: Quite 12 tornillos de la parte trasera de la chimenea y abra la cubierta trasera. Después de leer las instrucciones completas, compruebe que todos los controles Verá 2 tornillos grandes y 10 pequeños. de la chimenea estén en la posición de apagado (OFF).
  • Página 22 REPARACIONESS OpcióN 2: Utilice los soportes largos pegueños y los tornillos argos. En el caso de que surjan problemas con las piezas originales durante el montaje de la repisa, por ejemplo, que los paneles no puedan instalarse con el conector plástico, 1.
  • Página 23: Garantía

    GARANTÍA Todos los calefactores eléctricos de chimenea se prueban antes de salir de la fábrica y cuentan con una garantía de un año. Si la unidad no funciona correctamente dentro del año a partir de la fecha de compra, visite nuestro sitio web www.qualitycraft. com y haga clic en ayuda al cliente.

Tabla de contenido