Abbott ARCHITECT i RR-D2.04 Instrucciones De Sustitución

RR-D2.04 SENSOR, TEMP, REFRIGERATOR
Time Required
Tools/Materials
Removal
Prerequisite 1.
Preparation 1.
2.
Remove the Reagent
Carousel Cover
1.
2.
3.
©1998 by Abbott Laboratories
Abbott Park, IL 60064
13 min
#2 Phillips screwdriver
#1 Phillips screwdriver
The processing module must be in Stopped, or
Offline status.
Power OFF the processing module.
Lift the appropriate processing center cover(s)
to access the reagent carousel cover.
Note Use caution when removing screws;
they are not secured to the carousel
cover.
Locate the reagent carousel cover. [1]
Use the # 2 screwdriver to remove the three
(3) screws (non-captive) that hold the reagent
carousel cover in place. [2]
Remove the reagent carousel cover by using
the handle and lifting the cover up and out of
the module. [3]
Be careful not to damage other
Note
parts when removing the cover.
RR-D2.04 SENSOR, TEMP, REFRIGERATOR
ABBOTT ARCHITECT™ i System Removal & Replacement Procedure
Parts
76867 Sensor, Temp, Refrigerator
14494-104 Screw (1)
For further information, refer to the ARCHITECT i System Operations
Manual, Section 1: Use or Function, Subsection: System Status.
1 - 3
1
2
3
AMA-3182
ABBOTT ARCHITECT™ is a
trademark of Abbott Laboratories.
78154-102