Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 8
Installation Instructions
DKN-MG400, DKN-MG800,
DKN-MG1500
Installation and Configuration Instructions
NOTE: Installation must be done by a trained competent installation engineer following all local applicable guidelines. SV. OBS:
installation måste göras av en utbildad kompetent installatör efter alla lokala gällande riktlinjer. DE. Hinweis: Die Installation
und Inbetriebnahme muss von einem ausgebildeten Installateur unter Einhaltung der gültigen Normen und Richtlinien
erfolgen. FR. NOTA: La instalación debe ser realizada por un instalador competente capacitado conforme a las pautas
correspondientes locales. ES. REMARQUE: L'installation doit être effectuée par un installateur compétent formé suivant toutes
les directives locales en vigueur. CN. 注意:安裝必須遵循所有當地適用的原則訓練有素的合格安裝工程師來完成。RU.
Примечание: установка должна производиться обученным квалифицированным специалистом по установке с
соблюдением всех местных применимых руководящих принципов.
A. Applicable Products
SV. Tillämpliga produkter, DE. Anwendbare Produkte, FR. Produits applicables, ES. Productos aplicables
CN.適用產品.RU. Установка
Part Number
Transformer
DKN-MG400
30 VA
DKN-MG800
50 VA
DKN-MG1500
B. Mechanical Installation
SV. Mekanisk installation, DE. Mechanische Installation, FR. Installation mécanique, ES. Instalación mecánica, CN.機械安裝,
RU. Установка Механическая
1
2
6
© 2021 Daikin Refrigeration Malaysia. All rights reserved.
Document Number: F-28181-1
7
10
25 Nm
RISK OF BURNS OR FLYING PARTS
If the valve stem, spindle, or plug has been damaged, it may
blow out under pressure while servicing the actuator.
• Isolate and depressurize the valve before servicing.
• Manually check valve stem, spindle, or plug integrity by
moving it within the valve. If the part can be removed,
replace the valve assembly.
Failure to follow these instructions may result in death or
serious injury.
3
4
8
5-10 Nm
9
drm.daikinmalaysia.com |
CAUTION
SV/DE/FR/ES/CN/RU
5
11
February, 2021 tc
1
P.12
P. 2
Tabla de contenido
loading

Resumen de contenidos para Daikin DKN-MG400

  • Página 1 B. Mechanical Installation SV. Mekanisk installation, DE. Mechanische Installation, FR. Installation mécanique, ES. Instalación mecánica, CN.機械安裝, RU. Установка Механическая 5-10 Nm P. 2 25 Nm © 2021 Daikin Refrigeration Malaysia. All rights reserved. February, 2021 tc Document Number: F-28181-1...
  • Página 3: Manual Override

    向,根據開關7(正常/反向), RU. Направление управления согласно Переключателю (прямое/ обратное) SW2 MOD SW2 INC/DEC FEEDBACK (Y) MX VH VC G1 G0 NORM NORM NORM 0(2) V 0(2) V 24 V~ h100 VH VC VH VC © 2021 Daikin Refrigeration Malaysia. All rights reserved. February, 2021 tc Document Number: F-28181-1...
  • Página 8 Ley de Radiocomunicaciones de 1992. Guía de Configuración del interruptor DIP NOTA: Para sólo versiones DKN-MG400: 0% / 60 s, 300 s / 50% tiene una doble función, véase a continuación 6b .. NOTA: Para el actuador para registrar nuevos ajustes de los interrup- tores, la tensión de alimentación debe ser cortado o el mango de oper-...
  • Página 12 X: indicates that concentration of hazardous substance in at least one of the homogeneous materials used for this part is above the limit as stipulated in GB/T 26572 © 2021 Daikin Refrigeration Malaysia. All rights reserved. February, 2021 tc Document Number: F-28181-1...

Este manual también es adecuado para:

Dkn-mg800Dkn-mg1500

Tabla de contenido