Metra AX-TOY28SWC Manual De Instrucciones

AX-TOY28SWC
Toyota/Lexus/Scion ASWC Harness
AX-TOY28SWC
Introduction
When installing an aftermarket radio, the AX-TOY28SWC will allow
the user to retain their factory installed steering wheel controls
without having to splice into factory wiring (ASWC required and
sold separately). In addition we included RCA's to allow the user to
retain their factory installed 3.5mm jack (aftermarket radio must
have Aux-in).
APPLICATIONS
TOYOTA
4 Runner
Camry
Corolla
(Except TMC made)
Highlander
Matrix
Prius
RAV4
Sequoia
(NAV only)
Tacoma
(JBL only)
Tacoma
(All)
Venza
Yaris
(Hatchback only)
1-800-221-0932
REV. 7/23/13 © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
2012-2013
2012
2012-2013
2013
2013
2012
2012
2013
2012
2013
2013
2012
metraonline.com
AX-TOY28SWC
Installing
1. Connect the Red wire to 12 volt accessory.
2. Connect the Black wire to ground.
3. Connect male 3.5mm to your aftermarket radio SWC output.
4. Connect the White RCA to your aftermarket radio left AUX-in
5. Connect the Red RCA to your aftermarket radio right AUX-in
Note:
1. Audio devices connected through the 3.5mm jack will be controlled from
the audio device, not the aftermarket radio.
2. Please refer to the ASWC programming instructions for programming of
the ASWC.
1-800-221-0932
REV. 7/23/13 © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
(if equipped).
(if equipped).
metraonline.com