Axxess AXADBXH-CH1 Instrucciones De Instalación

INTERFACE FEATURES
• Provides accessory power (12-volt 10-amp)
• Maintains the retained accessory power (R.A.P.) feature
• Provides NAV outputs (parking brake, reverse, speed sense)
• Pre-wired AXSWC harness (AXSWC sold separately)
† To retain fade in amplified models, use the AXADBX-1
INTERFACE COMPONENTS
• AXADBXH-CH1 harness
• 4-pin harness with stripped leads
APPLICATIONS
See inside front cover
AxxessInterfaces.com
Chrysler Data Interface 2004-2009
INTRODUCTION
The AXADBXH-CH1 harness is designed for, and must be used with, the
AXADBX-1 or AXADBX-2 interface (sold separately). Please refer to the
AXADBX-1 or AXADBX-2 for the 16-pin connector with stripped leads.
• Can be used in both amplified and non-amplified models
• Retains balance and fade†
• Micro-B USB updatable
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
AXADBXH-CH1
I N S TA L L AT I O N I N S T R U C T I O N S
TABLE OF CONTENTS
Connections to be made
For models without an amplifier .......................3
For models with an amplifier ............................4
Installing & programming the AXADBXH-CH1
AXADBX-1 .............................................................5
AXADBX-2 .............................................................6
Adjusting the AXADBXH-CH1 .................................7
TOOLS REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink
• Small flat-blade screwdriver • Tape
• Wire cutter • Zip ties
CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
REV. 2/4/20 INSTAXADBXH-CH1