Blinds To Go Serenity Guia De Instalacion

Addendum for Serenity
if you purchased Serenity III
Due to a different bracket for Serenity III Shades, the following illustrations replace those in the main
guide's installation steps: "Getting Started" and "Fitting the shade into the brackets".
Serenity III bracket
front lip
spring tab
Fig. A
Serenity-III_Addendum_E 05-18-17
TM
ADDENDUM TO GUIDE 468355
Inside mount:
Note: For the shade to be flush within
the frame, the back edge of the brackets
should be 3 1 ⁄ " back from the front of the
4
frame.
Fitting the shade into the brackets:
1 After securing the Serenity III brackets onto the frame, hang the inside front edge
of the headrail onto the front lip of the bracket
2 Rotate the headrail back and upwards
until the back of the headrail engages
with the bracket's spring tab
3
PLEASE FOLLOW ALL OTHER INSTRUCTIONS IN
THE ORIGINAL GUIDE AND ADDENDUM, PAYING
CAREFUL ATTENTION TO SECURING THE CHAIN
/Cascade Installation Guide
TM
(fig. b).
Installed shade should fit securely in its brackets.
Shades
Outside mount:
(fig. a).
Fig. B
TM/® Blinds To Go Inc.