Gabriel HiJacker Guia De Instalacion

1. When installing the air line fittings, it is important that the air fittings and area around the fittings
are clean and free of debris.
2. Confirm each air fitting has one plastic nut, one compression ferrule, and two rubber O-rings.
3. For proper air flow, ensure the two rubber O-rings are no more than 1/8" away from the end of
the air line.
4. Tightly secure air lines to the frame to prevent snagging.
5. Make sure the air line is away from any moving components that could cut or damage the air line.
6. Ensure air line is three or more inches away from the exhaust pipe to prevent damaging the air line.
7. Shock should have adequate space around the top of the air can to prevent air leaks.
8. Securely mount the T-Valve to the vehicle where the T-Valve will not be damaged.
Bumper
Air Valve Location
Splash Shield
SPLASH SHIELD MOUNT
Tighten 3/4
of a turn past
finger tight
Drill 1/4" Hole
AIR PRESSURE WARNING
25psi MINIMUM
UP TO 1,100 lbs. OF LEVELING CAPACITY
HiJacker
INSTALLATION GUIDE
TYPICAL AIR VALVE MOUNTINGS
AIR VALVE OPTIONAL MOUNTINGS
BUMPER MOUNT
Valve Cap
Nut
Warning Tag
Rubber Seal
Washer
Nut
200psi MAXIMUM
Shocks
®
License Plate
Compression
Tube Nut
Ferrule
O-Rings Air Line
1/8"
Drill 1/4" Dia. Hole
Clip
429682009
Trunk Latch
Air Valve Mounting
TRUNK MOUNT
Rev. 2021