Champion 3Z172 Instrucciones De Funcionamiento Y Manual De Piezas

Operating Instructions & Parts Manual
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain
the product described. Protect yourself and others by observing all safety information. Failure to comply with
instructions could result in personal injury and/or property damage! Retain instructions for future reference
Champion Single-Stage Air
Compressor Pump
Description
Champion compressor head (air pump) is a single-stage, heavy-duty, industrial unit equipped with a centrifugal
unloader for loadless starting; counter-balanced, ductile iron crankshaft; tapered roller bearings; and domed cast iron
cylinders. The compressor pump also features Swedish steel disc-type valves, finned exhaust tubes, splash lubrication
system, visual oil-level gauge and balanced, fan-type flywheel.
Specifications
Bore & stroke............. 3-3/4 (2) x 3"
No. cylinders ....................................
CFM/REV....................................... .03830
Oil capacity .................................. . 2 qts.
Weight .................................
Max. pressure ......................
Min. operating speed..............
Max. operating speed ............. 1000 RPM
Dimensions
Figure 1 - Dimensions
viewed from
Form 5S1344 Version: 06
This reciprocating
compressor must not be used for
2
breathing air. To do so will cause
serious injury whether air is supplied
directly from the compressor source or
133 Lbs.
to breathing tanks for later use. Any
120 PSIG
and all liabilities for damage or loss
400 RPM
due to injuries, death and/or property
damages stemming from the use of
this compressor to supply breathing
air, will be disclaimed by the
manufacturer.
C443-B
(Ref. Drawing)
03/02/2011 © 2003 W.W.Grainger, Inc.
Printed in U.S.A.
02571
0796/2215//VCPVP
The use of this
compressor as a booster pump and/or
to compress a medium other than
atmospheric air is strictly non-
approved and can result in equipment
damage and/or injury. Non-approved
uses will also void
the warranty.
Ref Description
A Base width
B Bolt down width
C Bolt down to edge
D Base to crank center
E Overall width
F Overall height
G Add for Head unloader
H HP Exhaust opening
I Bolt down hole diameter
J Base depth
K Bolt down depth
L Bolt down to edge
M Bolt down to wheel (max.)
N Flywheel width
O Crank diameter
P Flywheel diameter
Q Flywheel grooves
R Overall depth
NOTE: Flywheel rotation clockwise when
front, flywheel to rear.
3Z172
.
E
N
G
L
I
S
H
E
S
P
A
Ň
O
L
Dim.
10"
4-3/8"
5/8"
5-1/2"
18"
19"
1"
3/4" NPT
15/32"
7-1/2"
5-3/4"
7/8"
F
2-5/8"
R
2-1/2"
A
16-1/2"
N
18-3/4"
C
2VB
Ă
20"
I
S