Yakima Locking RailRider 1 Manual De Instrucciones
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
DISASSEMBLE
TOWERS & BASES:
Refer to
Open the tower
RailRider Fit
levers using a key.
Sheet for
specific
With lever OPEN,
slide bases off.
vehicle
information!
To attach bases, insert screws through washers
and base. Do not tighten yet.
BE SURE SCREWS
HAVE ENGAGED THE
PLATES.
Locking RailRider 1
A
Once you have determined your
crossbar spread, measure for equal
distances on both sides of the vehicle.
B
Depressions in the bases
must face inboard on
vehicle's roof.
TOP VIEW:
US
Use existing nut-plates (4 per track)
when possible...
• Factory crossbars or accessories may need
to be removed.
• IF THERE ARE FEWER than 4 plates per
track, install additional plates following
Fit Sheet directions.
• See Fit Sheet for the exact plate and screw
specified for your vehicle.
Tighten bases to
tracks.
Be sure there is
no movement by
pulling the bases
in all directions.
Manuales relacionados para Yakima Locking RailRider 1
Resumen de contenidos para Yakima Locking RailRider 1
- Página 5 Locking RailRider 1 Asegúrese de que las Use las plaquetas (4 por riel) existentes DESMONTE depresiones de las bases siempre que sea posible… SOPORTES Y BASES: se orientan hacia adentro sobre el techo del Busque en la vehículo. Abra las palancas...
- Página 6 Yakima reparará o reemplazará el artículo defectuoso a su discreción, sin cargo alguno para el cliente. El cliente se compromete a pagar por el flete para enviar el producto a Yakima y Yakima pagará...