Husky HD219000 Manual De Instrucciones

Husky HD219000 Manual De Instrucciones

Clavador de armazones
Ocultar thumbs Ver también para HD219000:
Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

See Warranty on page 8 for important information about commercial use of this product.
Operating Instructions
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury, death and/or
property damage! Retain instructions for future reference.
Table Of Contents
General Safety . . . . . . . . . . . . . . 1 - 3
Specifications . . . . . . . . . . . . . . . . . 2
Operating The Nailer . . . . . . . . . . . 3
Operational Modes . . . . . . . . . . 4 - 5
Troubleshooting . . . . . . . . . . . . . . . 7
Fasteners . . . . . . . . . . . . . . . . . . . . . 7
Warranty . . . . . . . . . . . . . . . . . . . . . 8
Description
This nailer is designed for framing,
trusses, sub-floors, sheathing, exterior
decks, and pallet/create assembly.
Features include: convenient top loading
magazine, no-mar tip, adjustable
exhaust, single cycle trigger, and an
adjustable depth of drive mechanism.
Unpacking
After unpacking the unit, inspect
carefully for any damage that may have
occurred during transit. Make sure to
tighten fittings, bolts, etc., before
putting unit into service.
General Safety Information
This manual contains safety,
operational and maintenance
information.
Read this manual and
understand all safety warnings and
instructions before operating the
nailer. Contact your Campbell Hausfeld
representative if you have any
questions.
Safety Guidelines
This manual contains information that is
very important to know and understand.
This information is provided for SAFETY
and to PREVENT EQUIPMENT PROBLEMS.
To help recognize this information,
observe the following symbols.
an imminently hazardous situation
which, if not avoided, will result in
death or serious injury.
This tool meets or exceeds Industries' Standards as set forth by the American National Standard
Institute/International Staple, Nail and Tool Association in ANSI/ISANTA SNT-101-2002.
© 2007
a potentially hazardous situation
which, if not avoided, COULD result in
death or serious injury.
a potentially hazardous situation
which, if not avoided, MAY result in
minor or moderate injury.
important information, that if not
followed, may cause damage to
equipment.
CALIFORNIA PROPOSITION 65
You can create dust when you
cut, sand, drill or grind
materials such as wood, paint,
metal, concrete, cement, or other
masonry. This dust often contains
chemicals known to cause cancer, birth
defects, or other reproductive harm.
Wear protective gear.
or its power cord contains chemicals
known to the State of California to
cause cancer and birth defects or other
reproductive harm. Wash hands after
MANUAL
handling.
OPERATOR'S RESPONSIBILITY:
Before operating the nailer, read and
understand all safety warnings and
labels. Follow the operating
instructions outlined in this manual.
EMPLOYER'S RESPONSIBILITY:
Distribute this instruction manual to all
users before allowing use of the nailer.
Ensure all operators read, understand
and follow all safety warnings, labels
and instructions outlined in this manual.
G Do not use any type of
Danger
indicates
flammable gases or
oxygen as a power source
for the nailer. Use filtered,
REMINDER: Keep your dated proof of purchase for warranty purposes!
Attach it to this manual or file it for safekeeping.
Models HD219000, HD289000, & HD349000
Framing
Nailer
Warning
indicates
Caution
indicates
Notice
indicates
Locate model and date code on tool
magazine and cap and record below:
Model No. ________________________
Date Code ________________________
Retain these numbers for
lubricated, regulated compressed air
only. Use of a compressed gas
This
instead of compressed air may cause
product
the nailer to explode which will
cause death or serious personal
injury.
G Do not exceed maximum
operating pressure of the
nailer (120 psi). The nailer
will not function properly.
Do not use a compressed
air source capable of more
than 200 psi. The nailer could
explode which will cause death or
serious personal injury.
G Never use gasoline or
other flammable liquids to
clean the nailer. Never use
the nailer in the presence
of flammable liquids or
gases. Vapors could ignite by a spark
and cause an explosion which will
result in death or serious personal
injury.
O
CO
2
future reference.
120 psi
MAX.
IN724400AV 12/07
Tabla de contenido
loading

Resumen de contenidos para Husky HD219000

  • Página 17 Ver la Garantía en página 24 para información importante sobre el uso comercial de este producto. Models HD219000, HD289000 y HD349000 Manual de Instrucciones Sírvase leer y guardar estas instrucciones.Lea con cuidado antes de tratar de armar, instalar, manejar o darle servicio al producto descrito en este manual.
  • Página 18: Info. Generales De Seguridad .17 - 19 Especificaciones

    Componentes y especificaciones de la clavadora Deflector de escape de dirección ajustable HD219000 HD289000 HD349000 Agujero roscado/balanceador • REQUIERE mecánico (M8 x 1,25) /min con 16 clavos...
  • Página 19: Cómo Usar La Clavadora

    Modelos HD219000, HD289000 y HD349000 Medidas de Seguridad 2. Gire la clavadora de modo que la (Continuación) entrada de aire G No deje que la G Evite usar la clavadora cuando el Aceite ADVERTENCIA quede mirando herramienta se depósito está vacío. Ésto podría hacia arriba.
  • Página 20: Modos De Operación

    Manual de Instrucciones 5. Cambie la CICLO SENCILLO Cómo usar la Clavadora argolla Este método se (Continuación) retenedora recomienda para 3. Use mangueras en la punta la colocación de aire de 9,5 no des- exacta del clavo. mm diseñadas gastable, Le debe instalar para presiones luego...
  • Página 21 ANTI DISPARO SIN CARGA Trabajo hasta que contra la La HD219000 está equipada con una característica de anti disparo sin carga. Esto superficie de trabajo. Apriete el empujador evita que se presione el WCE cuando sólo gatillo. La clavadora DEBE OPERAR.
  • Página 22 Igualmente, deberá ponerle sujetadores. Use solamente partes de 2. Retire todos los un poco de aceite a todas las piezas repuesto Husky originales. Nunca clavos del substituya las partes. No use partes que se mueven y muñones. Finalmente, cargador (ver modificadas o partes que no den un después de haberla ensamblado y antes...
  • Página 23: Sujetadores

    Modelos HD219000, HD289000 y HD349000 Sujetadores La herramienta HD219000 también coloca sujetadores diseñados para: Campbell Hausfeld NS219000, Sears 18465, Porter Cable FR350, Hitachi NR83A, y Senco FramePro 702XP, 752XP, Ridgid R350RHA y DeWalt D51844, D51845. La herramienta HD289000 también coloca sujetadores diseñados para: Campbell Hausfeld NS289100, Sears 18420, Atro Helen 90CH, and Bostitch F28WW, N100S, N865, N805, N16.
  • Página 24: Garantía Limitada - Clavador De Armazones Husky 2-En-1 De Campbell Hausfeld

    Manual de Instrucciones Garantía Limitada - Clavador de Armazones Husky 2-en-1 de Campbell Hausfeld 1. DURACIÓN: Desde la fecha de compra por parte del comprador original, según se detalla: 1 (un) año. 2. QUIEN OTORGA ESTA GARANTIA (EL GARANTE: Campbell Hausfeld / The Scott Fetzer Company 100 Production Drive, Harrison, Ohio 45030 Teléfono: (800) 543-6400...

Este manual también es adecuado para:

Hd289000Hd349000

Tabla de contenido