SNOWJOE 24V-X2-SB18 Manual Del Operador

OPERATOR'S MANUAL
A Division of Snow Joe , LLC
®
IMPORTANT!
Safety Instructions
All Operators Must Read These
Instructions Before Use
Read all instructions when using cordless snow blowers.
Basic safety precautions should always be followed to reduce
the risk of fire, electric shock, and personal injury.
General Safety Rules
Notice the personal safety alert symbol
manual to draw your attention to a WARNING given along
with the particular operating instruction. This means that
the operation requires special ATTENTION, CAUTION, and
AWARENESS.
• Keep work area clean and well lit – Cluttered, dark areas
invite accidents.
• Keep bystanders away – All bystanders and pets should
be kept a safe distance away from the work area.
• Dress properly – Do not wear loose clothing or jewelry.
They can get caught in moving parts. Protective rubber
gloves and non-slip footwear are recommended when
working outdoors.
• Use the right product – Do not use this machine for any
job except that for which it is intended.
m
CAUTION! – Exercise caution to avoid slipping or falling.
•
Wear protective footwear that will protect your feet and
improve your footing on slippery surfaces.
• Use safety glasses – Also use safety footwear, snug-fitting
clothing, protective gloves, hearing and head protection.
• Do not force the snow blower – Use the snow blower
at the rate for which it was designed to ensure optimal
performance and safe operation.
• Stay alert – Watch what you are doing. Use common
sense. Do not operate the snow blower when you are tired
or under the influence of alcohol or drugs.
• Do not overreach – Keep proper footing and balance at
all times.
• Store indoors – When not in use, the snow blower should
be kept dry and stored out of the reach of children in a high
or locked place.
• Maintain snow blower with care – Follow instructions for
lubricating and changing accessories.
© 2020 by Snow Joe , LLC
®
All rights reserved. Original instructions.
CORDLESS SNOW BLOWER
R
48V MAX* | 4.0 Ah | 18-INCH | LED LIGHT
Model 24V-X2-SB18
m
used in this
m
WARNING!
Always disengage the switch lever and
remove the battery pack before making any adjustments,
inspecting, servicing, changing accessories, cleaning the snow
blower, or when any other dangerous conditions are present.
Any such operation should be performed after revolving parts
inside the snow blower stop completely. Such preventive
safety measures reduce the risk of starting the power tool
accidentally.
m
WARNING!
When replacing any parts, you must strictly
observe the instructions and procedures described in this user
manual. Special care should be paid to any rubber parts,
since these parts may increase the motor load and decrease
its mechanical power if damaged.
m
WARNING!
If you notice that the snow blower is not
running properly or hear abnormal sounds from the motor
when it is in use, immediately stop the machine, disconnect
the battery, and contact your service center.
• Surfaces – This snow blower is intended for use on
paved surfaces. Do not use on gravel, stone or other
unpaved surfaces unless the snow blower is adjusted for
such surfaces according to the instructions given in the
operator's manual.
• Moving parts present risks – Keep your face, hair,
clothing, hands, and feet away from moving parts.
All guards and safety attachments must be installed
properly before using the unit. Shut off and disconnect the
battery before touching any parts other than the handles
and switch.
• Avoid unintentional starting – Make sure the safety switch
and the switch lever are in the off position before inserting
the battery in the unit. Do not carry the snow blower with
the safety switch and the switch lever engaged.
• Do not overreach – Maintain proper footing and balance
at all times. Place heels firmly on the ground and tightly
grasp the handle bar. Watch for uneven surfaces and do not
overreach. In case you fall or collide with the snow blower,
inspect the unit for any damages or cracks. When stepping
backwards, be careful to avoid obstacles beneath your feet
or behind you to avoid falling.
m
WARNING!
If the snow blower strikes any object,
follow these steps:
i) Stop the snow blower. Remove the battery.
ii) Inspect for damage.
iii) Repair any damage before restarting and operating
the snow blower.
SAVE THESE INSTRUCTIONS
1
EN
Form No. SJ-24V-X2-SB18-880E-MR2