Echo SRM-260 Instrucciones Para La Instalación

For Models:
SRM-260/260S S/N ALL
SRM-261/261S S/N ALL
SRM-260/261SB S/N ALL
WARNING
You must install a Barrier Bar or U-Handle Kit and all Blade Conversion parts shown in the following instruc-
tions before operating this unit with blades, otherwise serious injury may result.
IMPORTANT
If non-standard monofilament heads, METAL/PLASTIC blades or cultivators etc., are used, THE CARBURETOR
MUST BE RESET or serious engine damage can occur. See "Carburetor Adjustment" in the unit Operator's Manual.
TO USE
THESE BLADES
You
must
install
these
parts!
• WARNING! DO NOT INSTALL BLADES ON GT (CURVED SHAFT) MODEL TRIMMERS
• Arbor diameter of Upper Blade Plate must match arbor diameter of blades.
• New cotter pin required each time blade is installed.
• Brush Cutters over 16.5 lbs (7.5 kg) dry weight (weight w/o fuel) require a double shoulder harness
C
ontents
1 U-handle assembly
1 Lower U-handle bracket (2 halves)
1 Harness clamp w/ring
1 5 x 18 mm bolt
1 8 x 55 mm bolt
1 Circular washer
1 Square nut
2 Throttle cable clips
3 5 x 30 mm bolts w/ washers
1 Shoulder Harnesss
1 Hip Pad
X7502098901
I
NSTALLATION INSTRUCTIONS
U-HANDLE KIT P/N 99944200661
SRM-261T
SRM-310/310S
SRM-311/311S
BLADe set-UP GUIDe
Pro Maxi-Cut
Grass/Weed
Blade
Loop Handle, w/or U-Handle or Loop Handle
w/o Barrier Bar
Plastic Shield
Harness
Upper Plate &
Flat Washer
Hex Nut
New Cotter Pin
S/N ALL
PAS-260
S/N ALL
PAS-261
S/N ALL
Rigid Plastic
Tri-Cut
Grass/Weed Blade
U-Handle or Loop Handle
w/Barrier Bar
Plastic Shield
Harness
Upper Plate
& Glide Cup
Hex Nut
New Cotter Pin
S/N ALL
S/N ALL
Metal Blade
w/Barrier Bar
Metal Shield
Harness
Upper/Lower
Blade Plates
Hex Nut
New Cotter Pin
X750004521
09/10