Setting The First Remote Control - Faac Tm2 Ery Manual De Usario

SETTING THE FIRST REMOTE CONTROL

This operation can only be performed when the motor is new, or after a total delete
of the memory.
During this step, power up only one motor at time!
T1: First remote control to be set
+
A B
T1
Every time you connect the power supply to the motor, you have 3 hours to
store the first remote control. After this time, the ability to store the remote
control is disabled. To reset the timer of the function you have to disconnect
and reconnect the power supply to the motor.
TM2 ERY
B
AUTOMATIC DISABLING OF THE FIRST
REMOTE CONTROL SETTING FUNCTION
T1
27
B
T1 (2 sec)
A4518_6G40_Rev.A