Taurus Alpatec AC280KT Manual De Instrucciones página 15

- Select the desired mode
- Select desired speed
FAN SPEED:
- Under the cooling and the fan mode, the speed
goes as follow: Lower fan – Mid fan – High fan.
- Under the dehumidifying mode, the fan is wor-
king in low speed.
TIMER FUNCTION:
- The appliance´s operating time can be control-
led from 1~24h.
- Press that button. If you press the button once,
the appliance will be working for 1 hour, if you
press twice, 2 hours, etc., up to 24 hours.
- Auto-shut off timer is only available when the
unit is on.
- Under the cooling mode, the setting temperatu-
re ranges from 16º~31ºC.
COLD MODE:
- Press mode to select cold mode, the cold
mode indicator will light up.
- Press + or - to set the temperature in a range of
16 ~ 31 °C.
- Pressing + or - once, the temperature will
increase or decrease gradually.
FAN MODE:
- Press mode to select the fan mode and the fan
indicator will light up.
- Press speed to select high speed or low speed.
- Temperature and sleeping function cannot be
setup.
DEHUMIDIFIER MODE:
- Press "MODE" to select dehumidifying mode,
dehumidifying mode indicator turns on.
- Under dehumidifying mode, sleeping function
cannot be setup, and fan speed is low.
SLEEPING MODE:
- Press key "SLEEP" enters into sleeping mode,
default value of fan speed is low.
- When sleeping mode turns on, under cooling
mode, the first one hour later, setting tempera-
ture will go up 1ºC, the second one hour later,
setting temperature will go up another 1ºC, and
then keep the same.
- Sleeping mode is invalid under dehumidifying
and fan mode. Under water full, machine stand-
by and mode conversion, sleeping mode will be
cancelled.
COMPRESSOR PROTECTION:
- Three minutes after pressing on / restarting,
the compressor will start to operate.
WATER DRAINAGE:
- When the inside of the water tank is full, the
indicator will light up on the display.
- The device enters the standby mode.
- Remove the plug to remove the water, turn the
machine off and on again, the machine will
operate normally.
- This model has a self-evaporating function, in
the cold mode, please do not make continuous
drains to get a greater effect of cold.
ONCE THE APPLIANCE HAS BEEN USED:
- Stop the appliance by pressing button (A) on
/ off
- Unplug the appliance from the mains.
CLEANING
- Wipe the appliance with a damp cloth impreg-
nated with a few drops of detergent. Do not use
solvents or products with an acidic or basic pH
factor such as bleach or abrasive products to
clean the apparatus.
- Do not immerse the connector in water or other
liquid or place it under the tap.
- If the appliance is not maintained in good
condition cleaning, its surface can be degraded
and inexorably affect the life of the appliance
and lead to a dangerous situation.
CLEANING THE AIR FILTER:
- Clean the air filters every 2 weeks. If the air
filter is blocked with dust, its effectiveness will
be reduced.
- Washing the air filters by submerging them
- Carefully in warm water with a neutral deter-
gent, rinse them off and let them dry complete-
ly in a shady place.
- Install the filters carefully after having them
cleaned.
AFTER PERIODIC MAINTENANCE:
- Switch off the appliance and remove the plug.