PocketWizard Plus II Manual Del Propietário

Owner's Manual Addendum v2.16
Plus II Transceiver
®
Upgraded Feature
High FPS/Short Pulse Mode
The Plus II is capable of triggering a remote flash at up to 12 Frames Per
Second (FPS) in sync with a fast motor drive camera. Some flashes that
are capable of high FPS operation cannot achieve this speed consistently
when connected to the Plus II using its default settings. To engage High
FPS/Short Pulse Mode and achieve maximum FPS:
1. Using a sync cable, connect the remote Plus II to the flash unit's
sync terminal normally.
2. Set the TRANSMIT MODE switch to REMOTE. The STATUS LEDs will
show a fast blinking pattern indicating High FPS/Short Pulse Mode.
3. Begin triggering normally.
Notes:
> This mode is only required for a receiving Plus II radio triggering a fast
flash. It does not need to be activated on a Plus II radio being used as a
transmitter on a camera. A locally connected fast flash on a transmitting
Plus II already uses High FPS/Short Pulse Mode. The TRANSMIT MODE
switch will perform its normal functions on a Plus II used as a transmitter.
See Page 7 of the Plus II Owner's Manual.
> High FPS/Short Pulse mode causes the Plus II's PORTs to use a contact
time (amount of time the PORTs are held triggered) of 5 milliseconds
instead of the default 62 milliseconds (needed for some remote camera
motor drives).
info@PocketWizard.com