Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Cordless Sweeper
Barredora Electrónica
Modelos:
Models/
V1950-V1950SP
7.2 Volt DC – 7,2 Voltios CC
To Maximize the life of your NiCd batteries:
1. Charge for a minimum of 20 hours before initial use.
Failure to do so will reduce the product's battery life
significantly.
2. Do not store unit with the charging adapter attached
and plugged in.
3. Only recharge when the batteries are fully discharged
(or as close to fully discharged as possible).
4. Do not store in areas of high temperature or humidity.
5. After 3 months of non-use, the product should be fully
discharged and then recharged to maximize battery
power.
6. Use only the charger supplied with the product. If other
chargers are used, the batteries can fail causing damage to
the battery, product, or personal property.
NiCd batteries have a long useful life but at some time they
will need to be replaced. To purchase replacement batteries,
visit www.sharkvac.com
Note: 1. The On/Off switch must be in the "Off" position in
order to charge the unit. If the charging indicator
does not light, depress the On/Off switch once.
2. If the product has never been used or has been
stored for an extended period of time without use – it
will take several complete charge and discharge
cycles to realize the full operational time of your
product.
EURO-PRO Operating LLC
Boston, MA 02465
Tel. : 1 (800) 798-7398
www.sharkvac.com
Copyright © EURO-PRO OPERATING LLC 2008
Tabla de contenido
loading

Resumen de contenidos para Shark V1950

  • Página 8: Medidas Importantes De Seguridad

    PARTES Y COMPONENTES MEDIDAS IMPORTANTES DE SEGURIDAD LEA TODAS LAS INSTRUCCIONES ANTES DE USAR SU BARREDORA INALÁMBRICA. Botón de Liberación del Mango Al usar aparatos eléctricos, siempre debe seguir precauciones básicas de seguridad, Mango Superior incluyendo las siguientes: Pivote ADVERTENCIA: Para reducir el riesgo de incendio, descarga eléctrica o daños personales: Botón de Vaciado Fácil 1.
  • Página 9: Fig. 4

    INSTRUCCIONES DE USO INSTRUCCIONES DE USO Armado de su Barredora Inalámbrica Instrucciones de Carga Su barredora inalámbrica requiere muy poco armado. Deberá sacarla de la caja y 1. Conecte el enchufe del cargador en el conector o agujero del costado de la familiarizarse con todos los componentes listados en el diagrama descriptivo.
  • Página 10: Extracción De La Batería

    INSTRUCCIONES DE USO INSTRUCCIONES DE USO Cómo Maximizar la Vida de sus Baterías de Ni-Cd 4. Extraiga cuidadosamente la batería y desconecte los terminales separando los conectores de los cables. Quite la batería de la unidad. (Fig. 7) 1. Cárguelas por un mínimo de 20 horas antes de usarlas por primera vez. El no hacer esto reducirá...
  • Página 11: Fig. 9

    INSTRUCCIONES DE USO INSTRUCCIONES DE USO 3. Para ajustar el mango a una posición confortable, aplique suavemente presión en la Limpieza del Recipiente de la Tierra parte superior del cabezal con su pie mientras tira del mango hacia atrás. (Fig. 9) Para obtener el mejor rendimiento, limpie el recipiente para la tierra luego de cada uso.
  • Página 12 INSTRUCCIONES DE USO INSTRUCCIONES DE USO Cambio del Cepillo Giratorio, Engranajes y Escobilla de Goma Deslice la correa sobre el cepillo. Inserte el otro extremo del cepillo en la ranura. (Fig. 19) 1. Quite el tubo de extensión del cabezal eléctrico de la barredora. 10.
  • Página 13: Garantía Limitada De Un (1) Año

    Retornando esta tarjeta usted reconoce haber leído y entendido las instrucciones de uso y advertencias incluidas en estas instrucciones. ENVIAR A: EURO-PRO Operating LLC, 4400 Bois Franc, St Laurent Qc H4S 1A7 V1950 – V1950SP _______________________________________________________________________________ Modelo del Artefacto...

Este manual también es adecuado para:

V1950sp

Tabla de contenido