Uline H-3029 Guia De Inicio Rapido

π
H-3029
MULTI-DIRECTIONAL
PALLET TRUCK
WARNING! Operator must read and understand
instructions here and on truck prior to use.
On the handle of the pallet truck, you will find the control
lever, which can be set in three positions.
(See Figure 1)
Figure 1
- DOWN = to lower the forks
- NEUTRAL = to move the load
- UP = to raise the forks
PAGE 1 OF 9
1-800-295-5510
uline.com
TECHNICAL DATA
MODEL
Standard Capacity
Lateral Capacity
Max. Fork Height
Min. Fork Height
Fork Length
Overall Fork Width
Fork Wheel Diameter
Lateral Wheel Diameter
Steering Wheel DIameter
Net Weight
OPERATION
If the forks elevate while pumping in the NEUTRAL
position, turn the setting screw clockwise until pumping
the handle does not raise the forks and the NEUTRAL
position functions correctly.
1.
2. If the forks do not descend when the control lever is
3. If the forks do not lift while pumping in the UP
Pour le français, consulter les pages 7-9.
H-3029
5,500 lbs.
3,300 lbs.
8"
3"
48"
27"
3" Polyurethane
2.5" Nylon
7" Polyurethane
160 lbs.
If the forks descend while pumping in the NEUTRAL
position, turn the setting screw counter-clockwise
until the forks do not lower.
in the DOWN position, turn the setting screw clockwise
until raising the control lever lowers the forks. Then
check the NEUTRAL position as per steps 1 and 2.
position, turn the setting screw counter-clockwise
until the forks elevate while pumping in the UP
position. Then check the NEUTRAL and DOWN
position as per steps 1, 2 and 3.
NOTE: When viewing the truck from the handle
side, the setting screw is located on the right
side of the pump above the right wheel. The
truck will lower faster or slower depending on
how far in or out the screw is adjusted.
Para Español, vea páginas 4-6.
1014 IH-3029