Knaack PowerCrew 500 Instrucciones De Instalación

SECURE JOBSITE STORAGE
Register Your KNAACK PowerCrew: Call 1-866-KNAACK1 or register online at www.knaack.com.
Model #
Approximate Installation Time: 10 min. per unit (0.15 hrs.) if 3" knock-out is present.
The following tools are required to install the KNAACK PowerCrew:
• Hammer (to remove knock-out)
• #2 Phillips screwdriver
• Center punch
• 3/8" Nut Driver (or adjustable wrench)
Quantity Description
1 Assembly Housing
1 Ground Bolt & Nut
1 Template
Incorrect use of this product can lead to serious injury or even death. Read and follow all warnings and instructions
before operating or using this product.
• The power connection to KNAACK PowerCrew must be supplied by extension cord plugged into 120V GFCI (ground
fault circuit interrupter) protected outlet with proper ground.
• If a GFCI outlet is not available, use extension cord with GFCI protection built in.
• DO NOT allow jobsite storage box covers or doors to close on extension or power cord coming from the
KNAACK PowerCrew.
• Protect the KNAACK PowerCrew from rain or liquid contact.
• Keep the KNAACK PowerCrew and other electrical equipment clean and free of moisture and dirt.
• DO NOT place electrical equipment in the bottom of the jobsite storage box.
• Your unit is equipped with a GFCI outlet. Conduct the simple test on page 4 to ensure proper function.
• Any modification or unintended use of this product shall immediately void all manufacturer's warranties.
• Knaack LLC disclaims all liabilities for injuries to persons or property resulting from any modifications to, or
unintended use of this product.
INSTALLATION INSTRUCTIONS
WWW.KNAACK.COM
READ THESE INSTRUCTIONS AND WARNINGS COMPLETELY.
KNAACK® PowerCrew™ is intended to provide 120V AC power to your
jobsite storage box allowing the recharging of battery-operated tools while
they are securely locked. KNAACK PowerCrew also allows you to work with
power tools right at the jobsite storage equipment location.
In the photo at left, the spring-loaded doors are open for demonstration purposes only.
PRODUCT REGISTRATION
Serial #
INSTALLATION TIME
TOOLS REQUIRED
• Contractor's 3" die punch (for those models without knock-outs)
• Tape
• Drill with 7/32" drill bit
PARTS LIST
Quantity
WARNING
NOTICE
KNAACK ® PowerCrew™
IN-BOX POWER SUPPLY
Model 500
Purchase Date:
Description
1 Access Cover
3 Access Cover Mounting Screws (#8 x 5/8")
1 Warning Decal
1
Place of Purchase:
Rev. A 10/08 Part No. 24-0276