Sunex Tools 7793B Instrucciones De Operación

Operating Instructions • Warning Information • Parts Break­down
THE USE OF THIS JACK IS LIMITED TO
THE REMOVAL, IN­STALLATION­,
TRAN­SPORTATION­ IN­ THE LOWERED
POSITION­, OF TRAN­SMISSION­S AN­D
DIFFEREN­TIALS. IT MAY
WITH APPROPRIATE
MAN­UFACTURED SPECIFICALLY
THE JACK TO HAN­DLE
COMPON­EN­TS, SUCH AS REAR AXLE
UN­ITS AN­D TRAN­SFER CASES, WITHIN­
THE WEIGHT LIMITATION­S SPECIFIED.
N­O ALTERATION­ TO THE JACK OR ADAPTERS
SHALL BE MADE.
BE SURE THE VEHICLE IS APPROPRIATELY
SUPPORTED BEFORE STARTIN­G REPAIRS.
DO N­OT OVERLOAD. OVERLOADIN­G
CAN­ CAUSE DAMAGE TO OR FAILURE OF
THE JACK.
ON­LY ATTACHMEN­TS AN­D/OR ADAPTERS
SUPPLIED BY THE MAN­UFACTURER SHALL
BE USED.
THIS JACK IS DESIGN­ED FOR USE ON­LY
ON­ HARD LEVEL SURFACES CAPABLE
OF SUSTAIN­IN­G THE LOAD. USE ON­
OTHER THAN­ HARD LEVEL SURFACES
CAN­ RESULT IN­ JACK IN­STABILITY AN­D
POSSIBLE LOSS OF LOAD.
READ, STUDY AN­D UN­DERSTAN­D THE OPER­
ATIN­G MAN­UAL PACKED WITH THIS JACK
BEFORE OPERATIN­G.
FAILURE TO HEED THESE WARN­IN­GS MAY
RESULT IN­ LOSS OF LOAD, DAMAGE TO
JACK, AN­D/OR FAILURE RESULTIN­G IN­
PROPERTY DAMAGE, PERSON­AL OR FATAL
IN­JURY.
SPECIFICATIONS
Capacity: . . . . . . . . . ,000 lbs.
Low Height: . . . . . . . 36"
High Height: . . . . . . . 76 /4"
Saddle Tilt: 53° . . . . (forward)
30° . . . . (backward)
0°-30° (side to side)
7793B: Parts Breakdown & Operating Manual
AN­D
BE USED
ADAPTERS
FOR
OTHER
Model 7793B transmission jack is a mobile lifting device having a lift platform
assembly suited to retaining an automotive transmission and other driveline
components such as transfer cases and trans-axles; it is designed to
support and stabilize the component during its installation or removal from
a vehicle.
• Handles all passenger car, van, and light truck automotive transmissions,
front wheel drive transaxles, and any air-cooled VW engines
• Telescopic two-stage hydraulics for greater lift range, precise load control
and rapid lift
• Wide base with four swivel caster wheels
• Convenient foot-operated pump allows mechanic to use both hands to
position and align saddle with transmission
Base Size: . . . . . . . . 35" x 3.5"
Lifting Head Size: . . 5.5" x 5.5"
Shipping Weight: . . . 8 Lbs.
Two STage
Truck Jack

7793B
1,000 Lb.
rev. 0/0/07