Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 41

Enlaces rápidos

SERIAL #______________________
BUILT-IN UNIT INSTRUCTION GUIDE
Please use this manual in conjunction with your main manual to properly assemble your built-in grill. Refer to the main
manual for operating, cleaning, and maintenance instructions. This grill is designed for NON-COMBUSTIBLE enclosures
only, and must be installed and serviced by a qualified installer to local codes.
BUILT IN PROPANE GAS HOOK-UP:
The piping up to the gas grill is the responsibility of the installer and piping
should be located as shown in the built-in instructions. Do not use hose to connect the unit. It must be connected with
either rigid pipe, copper tube or an approved flexible metal connector. The installation must comply with all local and national
codes. The gas supply must be connected to the 3/8" flare fitting located under the right hand side of the control panel. If
installing a side burner, a separate line must be branched off to the side burner unit and enter the side burner opening at the
specified location. If the enclosure is to house a propane cylinder, the tank portion of the enclosure must be ventilated
according to local codes, and must not have communication with the cavity used to enclose the gas grill. A propane tank
can not be stored below the gas grill.
BUILT IN NATURAL GAS HOOK-UP:
The piping up to the gas grill is the responsibility of the installer and piping
should be located as shown in the built-in instructions. Do not use hose to connect the unit. It must be connected with
either rigid pipe, copper tube or an approved flexible metal connector. The installation must comply with all local and national
codes. The gas supply must be connected to the 3/8" flare fitting located under the right hand side of the control panel. If
installing a side burner, a separate line must be branched off to the side burner unit and enter the side burner opening at the
specified location.
Built in units are supplied with a drip pan which holds only a minimal amount of grease. To prevent grease fires,
the pan must be cleaned after each use.
DANGER: READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING GRILL. FAILURE TO FOLLOW
THESE INSTRUCTIONS EXACTLY COULD RESULT IN A FIRE CAUSING SERIOUS INJURY OR DEATH.
N415-0174CE MAR14/11
Tabla de contenido
loading

Resumen de contenidos para Napoleon BIM485

  • Página 41: Número De Serie

    Número de serie Parrilla empotrada: Manual de instrucciones Utilice este manual y el manual del usuario para ensamblar correctamente la parrilla. Consulte el manual principal para obtener más información sobre instrucciones de funcionamiento, mantenimiento y limpieza. Esta parrilla está diseñada para uso exclusivo en espacios no combustibles. El manejo y la instalación del producto deben realizarse por un instalador calificado y de acuerdo a los códigos locales.
  • Página 42: Dimensiones De Espacio De Instalación De La Unidad

    SE REQUIRE UN MÍNIMO DE 65 CM² PARA LA VENTILACIÓN A CADA LADO DEL GABINETE. EL MARCO Y EL GABINETE DEBEN SER DE MATERIALES NO COMBUSTIBLES. MODELO DIMENSIÓN DEL ESPACIO NOTAS PROF. ALT. BIM485 75,5cm 54,5cm 19cm BIM605 93cm 54,5cm 19cm BIM730 110cm 54,5cm 19cm Se recomienda un espacio de 32 cm²...
  • Página 43: Dimensiones De Espacio De Accesorios

    DIMENSIONES DE ESPACIO DE ACCESORIOS PROF NOTA: MARCOS DE ACCESORIOS TRASLAPAN 4CM EN TODOS LOS LADOS DE LA APETURA DIMENSIÓN DE APERTURA Pieza n. ° Descripción Imagen PROF 34cm 46,5cm N370-0069 Puerta plana, vertical, pintada. 34cm 46,5cm N370-0071 Puerta plana, vertical, de acero inoxidable 46,5cm 34cm N370-0070 Puerta plana, horizontal, pintada.
  • Página 44: Instrucciones De Ensamble De Bim485

    1. INSTRUCCIONES DE ENSAMBLE DE BIM485 N710-0054 N585-0044 N080-0216 N570-0073 N080-0216 N475-0263 N715-0084 N010-0563-30 (LP) COLOQUE LAS BATERÍAS COMO LO INDICA LA IMAGEN. CONECTE EL CABLE DE LAS LUCES LED UBICADAS DEBAJO DEL PANEL DE CONTROL AL CABLE DEL COMPARTIMIENTO DE LAS BATERÍAS. COMPRUEBE QUE LOS CABLES NO ESTÉN EN CONTACTO CON LA PARTE INFERIOR DE LA...
  • Página 45: Instrucciones De Ensamble De Bim605

    2. INSTRUCCIONES DE ENSAMBLE DE BIM605 N710-0055 N585-0045 N080-0216 N570-0073 N080-0216 N475-0243 N715-0085 N010-0544-30(LP) COLOQUE LAS BATERÍAS COMO LO INDICA LA IMAGEN. CONECTE EL CABLE DE LAS LUCES LED UBICADAS DEBAJO DEL PANEL DE CONTROL AL CABLE DEL COMPARTIMIENTO DE LAS BATERÍAS. COMPRUEBE QUE LOS CABLES NO ESTÉN EN CONTACTO CON LA PARTE INFERIOR DE LA PARRILLA.
  • Página 46: Instrucciones De Ensamble De Bim730

    3. INSTRUCCIONES DE ENSAMBLE DE BIM730 N710-0056 N585-0046 N080-0216 N570-0073 N080-0216 N475-0244 N715-0086 N010-0546-30(LP) COLOQUE LAS BATERÍAS COMO LO INDICA LA IMAGEN. CONECTE EL CABLE DE LAS LUCES LED UBICADAS DEBAJO DEL PANEL DE CONTROL AL CABLE DEL COMPARTIMIENTO DE LAS BATERÍAS. COMPRUEBE QUE LOS CABLES NO ESTÉN EN CONTACTO CON LA PARTE INFERIOR DE LA PARRILLA.
  • Página 47: Instrucciones De Ensamble Del Quemador Lateral

    4. INSTRUCCIONES DE ENSAMBLE DEL QUEMADOR LATERAL N280-0003P (NEGRO) N280-0004 (ACERO INOXIDABLE) Coloque la estructura del quemador lateral en la apertura. La estructura debe ajustarse a la apertura para evitar movimientos (seguros no incluidos) Compruebe que haya un espacio mínimo de 32 cm² en la parte inferior del recorte para permitir la combustión de aire. Coloque el quemador lateral en la estructura.
  • Página 48: Instrucciones De Ensamble De Cajones

    5. INSTRUCCIONES DE ENSAMBLE DE CAJONES Desempaque la estructura del cajón para ensamblar. Deslice completamente y levante los cajones para retirarlos de las barras corredizas y luego, del gabinete. Coloque espaciadores en la apertura para garantizar que el gabinete se ajuste bien. Compruebe que los espaciadores laterales estén colocados a la misma altura que los orificios del gabinete.

Este manual también es adecuado para:

Bim605Bim730

Tabla de contenido