General Electric GX1S01R Instrucciones De Instalación

Installation
Instructions
■ Check with your local public works department
for plumbing codes. You must follow these guidelines
as you install the Water Filtration system.
■ Use the Water Filtration system on a potable, safe-to-drink,
home COLD water supply only. The filter cartridge
will not purify the water or make it safe to drink.
■ DO NOT use on a hot water supply. Cold water supply only
(40-100° F).
■ Install or store where it will not be exposed to temperatures
below freezing or exposed to any type of weather. Water
freezing in the system will damage it.
■ Your Water Filtration system will withstand up to 125 pounds
per square inch (psi) water pressure. If your house water
supply pressure is higher than 100 psi, install a pressure
reducing valve before installing the Water Filtration system.
REQUIRED TOOLS FOR INSTALLATION
■ Phillips screwdrivers
■ Pliers
■ Adjustable wrench
REQUIRED PARTS FOR INSTALLATION
•
3/8" Tubing (Pex or Plastic)
•
2-3/8" NPT Fittings
•
Teflon Tape
®
•
2-3/8" Nuts
•
2 Tube Inserts
•
Sump Wrench - UCWRNCH
This GX1S01R is Tested and
Certified by NSF international
against NSF/ANSI Standard 42
for materials and structural
C US
integrity requirements and
COMPONENT
against CSA B483.1.
SAFETY PRECAUTIONS
49-50247-1
GENERAL ELECTRIC COMPANY, Appliance Park, Louisville, KY 40225
Water Filtration System
GX1S01R
WARNING:
is microbiologically unsafe or of unknown quality
without adequate disinfection before or after the system.
Systems certified for cyst reduction may be used
on disinfected water that may contain filterable cysts.
Discard all unused and packaging material after installation.
Small parts remaining after installation could be a choke hazard.
OPTIONAL KITS AND TOOLS FOR INSTALLATION
NOTE: Sump wrench (UCWRNCH) and faucet (UNFCTBL)
are sold separately for model GX1S01R.
■ Drill and 1/4" bit (saddle valve installation)
■ Drill and drill bit for 3/4" hole (type as required)
if mounting hole is needed for faucet
■ Pipe cutter
■ File
CAUTION:
To avoid damaging the sink, consult a
qualified plumber or installer for drilling procedures. Special
drill bits may be needed for porcelain or stainless steel.
JR 10-08
1
Do not use with water that