Titan Controls Apollo 3 Guía Sencilla

http://waterheatertimer.org/Woods-timers-and-manuals.html#cycle
Apollo 3
Fixed Cycle Timer
Easy Guide
VANCOUVER, W ASHINGTON U.S.A.
Instructions for Use
1. Mount Apollo 3 near equipment to be operated,
away from water, mist, etc.
2. Plug equipment to be controlled into the Apollo 3.
3. Do not exceed 10 amps.
4. Plug the Apollo 3 into a 120 volt outlet.
5. Equipment will cycle one (1) minute "On"
and four (4) minutes "Off" until power is defeated.
6. To reset Apollo 3, unplug timer & then plug
back into outlet. Timer will always start with the
"On" cycle.
Controller Specifi cations
Size: 4" 2" 2.5"
H x W x D
Weight: 1 lb.
Voltage Input: 120 volts
Voltage Output: 120 volts
Maximum Amperage: 10 amps
Hertz: 60 Hz
On Time: 1 minute
Off Time: 4 minutes
o o
Operating Temperature: 35 to 125 F | 2
o o
Storage Temperature: 32 to 135 F | 0
Cord Set: Wall mount
www.titancontrols.net
For technical assistance call us at
1-888-80-Titan or 1-888-808-4826.
Aeroponics System
Apollo 3
Ebb & Flow System
Apollo 3
o o
to 53 C
o o
to 57 C
Controlling a Drip Feed
Apollo 3
Controlling an
Controlling an