Yakima Raptor aero Guia De Inicio Rapido

RaptorAero
SPRing (1)
thReAded Plug (1)
cliP (1)
wheel
StRAP (2)
wheel tRAy
end cAP (2)
wheel tRAy (1)
(bASePlAte)
ROUND AND SQUARE BARS
AttAchment hARdwARe
elongAted key (2)
SnAP ARound (3)
bASePlAte bolt (2)
IMPORTANT WARNING: IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY
ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD
CAUSE SERIOUS BODILY INJURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS
AND ACCESSORIES TO YOUR CAR, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE
PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS
AND CAUTIONS SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL
OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY FAMILIAR
WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER SUCH AS
A QUALIFIED GARAGE OR AUTO BODY SHOP.
1033402A-1/18
guide Plug (1)
knob
(jAw)
(hooP ASSembly)
ShoRt cARRiAge
bolt (1)
wASheR (1)
lock wASheR (1)
wing nut (1)
(univeRSAl mighty mountS)
Crossbar-spread
requirements:
(diStAnce between toweRS)
1 or 2 bikes . ......... 16" min. — 38" max.
moRe thAn 2 bikeS on Round oR SquARe bARS only:
3+ bikes . ......... 18" min. — 38" max.
Red
faCtory bar weight limits
2 bikes = maximum load
(1)
each bike = 30 lbs./14 kg
(do not exceed rack weight limit)
wheeltRAy
bolt (1)
hex key (1)
FACTORY BARS
AttAchment hARdwARe
(univeRSAl mighty mountS)
wRench (1)
ShoRt wheel
tRAy bolt (1)
long cARRiAge
bolt (2)
ShoRt hex bolt,
foR SmAll bAil (3)
long hex bolt,
foR lARge bAil (3)
bARRel Sleeve (3)
SPAceR (3)
bAckbone (3)
nut (3)
Set of PAdS (3)
SmAll bAil (3),
mARked "A"
lARge bAil (3),
mARked "b"
thumb-wheel (3)
Part #1033402 Rev.A