Yakima Universal MightyMount Manual Del Usuario

install Universal
MightyMounts opening to
the front of the vehicle.
(shown for accessory, cobra bike carrier)
• Follow the Fitting Process
on the next page to match
the size of your factory or
square bars.
• Do not install
KayakStackers (single-
post style), HullRaisers, or
AnkleBiters. They will not
work with this product.
IMPORTANT WARNING!
IT IS CRITICAL THAT ALL YAKIMA RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE.
IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY
OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR,
CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT,
WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS
SUPPLIED WITH YOUR YAKIMA PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE
INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY FAMILIAR
WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER
SUCH AS A QUALIFIED GARAGE OR AUTO BODY SHOP.
1033297H - 1/24
— Universal —
MightyMount
4 EACH:
Kit contains 4 of each piece of hardware
(excluding the wrench).
sHoRt Hex bolt
(for small bail)
long Hex bolt
(for large bail)
bARRel
sleeve
set of PADs
sMAll bAIl
(marked "A")
lARge bAIl
(marked "b")
tHuMb-WHeel
sHoRt
cARRIAge bolt
long cARRIAge
bolt
sPAceR
ADAPteR
bAcKbone
nut
YAKIMA
WRencH
Part #1033297 Rev.H