Scanning; Fixed Keys; Ptt (Press To Talk); Monitor - Maxon CIC Europe S5 Manual De Usuario

User Manual

Scanning

Scanning is a Dealer programmable feature that allows you to monitor a number of channels.
Your Dealer will help you define a scanning mode and your channel "scan list".
Normal Channel Scan
Once the scan list has been established, initiate scanning by pressing the scan key or holding the
monitor button and rotate the channel switch to scan the enabled channels. Then the Green LED
flashes to confirm the scanning.
If a conversation is detected on any of the channels in the scan list, the radio will stop on that
channel and you will be able to hear the conversation.
If programmed for normal scan TX, you will be able to transmit on that active channel during the
programmable scan delay time. (The scan delay time is the amount of time the radio will stay on
that channel once activity has ceased. Dealer programmable, 4-7 seconds is typical). The radio will
resume scanning once the scan delay time has expired, and will continue to scan until the channel
is changed. The LED will flash green.
When in scan mode, if power is switch off and on, the radio reverts back to "scanning"
automatically.
Nuisance Scan Delete
If there are any unwanted signals on any of the channels being scanned, they can be temporarily
removed from the scan list. When the scanning feature has locked onto the unwanted signal simply
press the monitor button. This will delete that channel from the scan list. When the radio is
switched off and back on the channel is restored in the scan channel list.
Priority Channel Scan
A single channel may be programmed as the "Priority" channel. The radio will constantly monitor
this channel while scanning. If a call is detected on the priority channel, the radio will automatically
move to, and remain on, the priority channel activity takes precedence over all other conversations.

Fixed Keys

PTT (Press to Talk)

Press and Hold to transmit. Release to enter the receive mode.

MONITOR

Releases the squelch and tone circuit to check whether the channel is busy.
OPTION
Short pressing:

EMG

Transmits EMG ID 5 times and generate warning audio alert for a duration of 7 secs.
Page 13
Enable/disable scan
Look Back channel edit
English
S5