Honeywell RCWL301A Manual De Instrucciones

RCWL301A Instruction Manual
Premium Portable Wirefree Chime with Push, Converter, and Door Contacts
Thank you for choosing this Honeywell product. Please use the following instructions
to ensure correct installation and use. Keep these notes in a safe place for future
reference.
Checking Pack Contents
Unpack your chime kit and identify the following parts:
• Chime (51360SL)
• Wall mounting bracket
• Bell push (51368SL)
• Bell push/converter/extender (51371SL)
• Door contacts
• 2x CR2032 battery for bell push and converter
• 4x mounting screws for door contacts
• 4x mounting screws for push/converter
• 2x mounting screws for chime
• 2x wall anchors
• 2x adhesive pads
• Bell wire (for use with converter and door contact)
• Self-adhesive icons
You will need:
• 3x LR6 'AA' Alkaline batteries
• Phillips screwdriver
• Small flat bladed screwdriver
• 1/4-in. (6 mm) masonry drill
Safety
Before proceeding with the installation, please note the following safety warnings:
• Always follow the manufacturer's advice when using power tools and wear suitable
protective equipment (e.g. safety goggles) when drilling holes, etc.
• Before drilling holes in walls, check for hidden electricity cables and water pipes.
The use of a cable/pipe locator is advisable if in doubt.
• Batteries (battery pack or batteries installed) shall not be exposed to excessive heat
such as sunshine, fire or the like; danger of damage if battery is incorrectly
replaced. Replace only with the same or equivalent type.
Quick Start
The bell push and converter supplied with this kit are pre-programmed to operate with
the chime. You need to do the following to get started:
• Open the bell push and the converter
• Fit the push and converter batteries
• Fit the chime batteries
• Check the volume setting
When you operate the bell push and converter, the chime will sound and the icon will
flash.
To use the door contacts, you need to wire them to the converter. Please refer to
steps in Wireless Converter/Extender/Push and Door Contact for setup.
If you use an additional push and converter or you want to assign a different
icon to your push, you will need to follow the Programming Procedure.
Open the Bell Push
Insert a flat bladed screwdriver into the slot A at the base of the push. Carefully lever
the cover and base apart (Fig. 1).
Fig. 1
A
M27199
Fit the Push Battery
Insert the CR2032 coin cell. Ensure the face marked '+' is uppermost (Fig. 2).
CR2032
Fig. 2
Fit the Chime Batteries
To remove the chime battery cover, press at point B and slide the cover back 1/4 in. (5
mm), then lift off. Insert 3 x LR6 'AA' alkaline batteries (not supplied). Observe polarity
as marked inside the battery compartment (Fig 3).
B
Fig. 3
Sliding Window
Release the catch (B) and slide open the window (Fig. 4).
B
M27201
Fig. 4
69-2139EFS—03
+
M27153
M27200
1