RISCO Group VUpoint RVCM52W Guia De Instalacion página 8

Note:
 For reset (used to return the camera settings to factory default mode), long
press for 15 seconds and then the light turns off
 For WPS (Wi-Fi Protected Setup), one quick press.
Indication
Red light normally on
Green light slow
flashing
Green light quick
flashing
Green light normally
on
Red and green lights
flash alternately
Red light slow flashing
Red light quick
flashing
Status
Booting
Booting completed, await WiFi config, enter smart config status;
WiFi smart config in progress, including WPS (WiFi Protected
Setup), management frame and etc.
Wifi connection succeeded, operate normally.
Device upgrade
Network connection failure or disconnection after network
connection success.
Device malfunction, fail to boot up; alarm or SD card
malfunction
Figure 3 IP Camera Dimensions
6