FAB LIGHTER CAR Manual Del Usuario

Frequency below 433 MHZ is forbidden in Europe, They are just allowed in countries where they are authorized, any
handling and used of these is buyer responsibility.
With compliance with DIRECTIVE 1999/05/CE
MANUFACTURED BY /FAB: ESB06450563
Programming instructions
1. Locate the selector switch in the back of the remote. Use a paper clip or small object to pry up the
rubber cover to expose the selector switch.
2. Set your selector switch for the desired manufacture. See Chart Below
3. The remote is ready to be used, please refer to your receiver's user manual.
Note: To programming BFT, MUTANCODE and ERREKA- Hidden button (beside the switches) will be
necessary.
Lighter Car
MANUAL
LIGHTER CAR
TECHNICAL FEATURES
✓ Model LIGHTER CAR
✓ Frecuencies 300-900 Mhz
✓ 3 Channels
✓ SPECIAL CHIP
✓ SOFTWARE NEW CLONER
ATTENTION: THIS REMOTE WORKS IN TWO DIFFERENT WAYS:
1. ENTERING DIRECTLY IN THE RECEIVER
2. CLONING
PATENTED