Battery Status Indication - Giesse Rc Manual De Uso E Instalación


To erase the memory, go to the channel 00 and press the STOP button.
After the memory has been erased, all the channels start flashing. To exit,
press the M button again for 1 second.
Checking the composition of a memory sequence

From the wait state, press the M button; the M1 icon will be activated.

The stored sequence of channels appears on the display (e.g.: 1-2-3-4-
pause, 1-2-3-4-pause, etc.).
Control of a stored sequence - M1 and M2 Memories.
Starting from the wait state, press the M button and the steady-on M1 icon will
appear on the display; using the ▲▼ buttons activates the function, transmitting
the command to the channels of the M1 sequence. The stored channels scroll
cyclically and continuously on the display.
Starting from the wait state, press the M+CH button and the steady-on M2 icon
will appear on the display; using the ▲▼ buttons activates the function,
transmitting the command to the channels of the M2 sequence. The stored
channels scroll cyclically and continuously on the display.
The STOP button stops the command.
Press the M button once to exit from the memory sequence control state, and the
M1 or M2 icon disappears; now it is possible to activate the commands of all the
individual channels.
F1 and F2 Function buttons
The F1 and F2 function buttons are dedicated to manage special functions if
foreseen in the dedicated motor; they are described inside its own manual.
WARNING:
For all the other "normal" applications – i.e., those not supported by the devices
described above - where the radio remote control is used, regardless of the
channel number on which it is set, if the steady-on F1 or F2 icon appears on the
display,
NOTHING MOVES
functions are not associated with any type of command.
I ,
N THIS CASE THE
.
USE

6. Battery status indication

The level of the battery charge is measured at each passage from the standby state
to the wait state. The level is shown on the display using the battery indicator:
Level above 2,6V
Level between 2,4V
Level between 2,2V
Level below 2,2V
when the ▲▼ buttons are pressed because these
F1 F2
AND ICONS SHOULD NEVER APPEAR ON THE DISPLAY DURING
:
and 2,6V
and 2,4V
:
3 bars lit
2 bars lit
1 bar lit
0 bars lit – all off
23