Ups Setting - INFOSEC UPS SYSTEM E4 VALUE 1000 IEC Manual De Usuario

3.4. UPS setting

To open the settings menu via the buttons on front face, please refer to the chapter 3-1.
LED6 LED7 LED8 LED9 LED10
LED1 LED2 LED3 LED4 LED5
LED3 flashing: Output voltage setting

Interface
LED4 flashing: Bypass enable/disable when UPS is off

Interface
00: Exit setting

Interface

Setting in " Frequency Converter Mode " et "ECO Mode"
These two operation mode are setting directly via the communication software Infopower :
- Step 1 : please refer to the chapter 2-3-step 3 for the installation, then rubric « UPS
setting », « Parameters setting »
- Step 2 : select the functions by clicking "Enable" or "Disable" button. Or change the
numbers by clicking up-down arrows or modify the numbers directly in the number column.
- Step 3 : Click "Apply" button to save the settings. Each function setting is saved by
INFOSEC UPS SYSTEM – 15 rue du Moulin – 44880 Sautron – France – www.infosec-ups.com
29
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 05 16 AA 59 204 10
LED3 or LED4 flashing indicates setting
program. There are two setting programs.


LED7, LED8, LED9 and LED10 flashing
indicates value or disable selection.
Setting
For 200/208/220/230/240 VAC models, you may choose
the following output voltage:
LED7: presents output voltage is 208Vac
LED8: presents output voltage is 220Vac
LED9: presents output voltage is 230Vac
LED10: presents output voltage is 240Vac
Setting
Enable or disable Bypass function. You may choose the
following two options:
LED8: Bypass enable
LED9: Bypass disable
Setting
Exit setting mode.
LED3: Output voltage setting
LED4: Bypass enable/disable when
UPS is off