Celestron Piggyback Manual De Instrucciones

P
iggyback
The Celestron Piggyback Mount is a great accessory for
all observers interested in deep-sky astrophotography.
This specially designed adapter allows you to attach
your camera to the top of any Celestron SCT/ EdgeHD
telescope. When using with a NexStar SE model,
the adapter can be mounted while still utilizing your
StarPointer finderscope for telescope alignment.
I – F
nstallatIon
1. Remove the two screws on the rear cell of the telescope
tube that attach the StarPointer finderscope.
2. Align the slotted holes on the piggyback mount with the
holes in the rear cell of the telescope.
3. For NexStar SE models - Place the StarPointer on top of
the piggyback adapter so that the holes on the
StarPointer bracket overlap the holes on the adapter.
(It may be easier to remove the StarPointer from its
bracket first).
F 1 – P
igure iggyback adaPter on
M
InstructIon Manual
5", 6", 8"
or and
nXSe
– F
ount
ItEM #93609
Included with the Piggyback Mount are the following items:
• Piggyback Mount Assembly
• Adapter plate (for 11" and 14" SCT)
• Two – M4 x 16 mm Mounting Screws for 6 SE
Telescopes
• Two – 8-32 x 5/8" Mounting Screws for 5 SE,
8" and 9.25" Telescopes
• Two – 8-32 x 7/8" Mounting Screws for C11 and C14
9.25" M
odels
4. Take the appropriate size screws included with the
adapter and insert them through the holes, tightening
them until the adapter is flush against the rear cell.
5. You are now ready to mount a camera or spotting scope
on top of the piggyback mount. To do this, locate the
threaded mounting hole on the bottom of your camera
or spotting scope. Place the camera or spotting scope
on the top of the piggyback adapter and thread in the
1/4 - 20 bolt and tighten.
¼"x20
Mounting Bolt
F
igure
Sct'
or all
2 – W P
ith the iggyback
c
and amera attached
english
S
Piggyback
Adapter
StarPointer
Finderscope
a , S P
daPter tar ointer
.