TDK-Lambda Z36-24-LAN-L-U Manual De Instrucciones

EN
General Safety Instructions:
READ SAFETY INSTRUCTIONS
The following safety precaution must be observed during all phases of operation, service
and repair of this equipment. Failure to comply with the safety precautions or warnings in
this document violates safety standards of design, manufacture and intended use of this
equipment and may impair the built-in protections within. TDK-Lambda shall not be liable
for user's failure to comply with these requirements.
Servicing:
These products are not customer serviceable. Parts substitutions and modifications are by
authorized TDK-Lambda service personnel only. For repairs or modifications, the product must be
returned to TDK-Lambda service facility.
Critical Components:
These products are not authorised for use as critical components in nuclear control systems, life
support systems or equipment for use in hazardous environments without the express written
approval of the Managing Director of TDK-Lambda Ltd.
Product Usage:
These products are designed for use as standalone equipment within a limits described in
product Manual.
Environmental:
These products are IP20, and therefore chemicals/solvents, cleaning agents and other liquids
must not be used.
Environment:
These products are designed for use within a Pollution Degree 2, Overvoltage Category II
environment.
Output Loading:
The output power taken from the products must not exceed the rating stated on the product label,
except as stated in the product Manual.
Input Parameters:
These products must be operated within the input parameters stated in the product Manual.
End of Life Disposal:
The products contains components that require special disposal. Make sure that the unit is
properly disposed of at the end of its service life and in accordance with local regulations.
RISK OF ELECTRIC SHOCK
High Voltage Warning: Dangerous voltages are present within the power supply. To avoid
injuries, always disconnect power, discharge circuits and remove external voltage sources before
touching components.