DEFLECTA-SHIELD Delta III Instrucciones De Instalación

For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-328-5863.
Important Safety Information
WARNING:
CAUTION:
Contents
Note: Not all fasteners are used in every kit.
M8-1.25
X8
M8-1.25 x 20MM
X16
1/4 FLAT WASHER
1/4-20
1/4-20 x 3/4"
X8
Black
X4
318-A
X2
Gasket
Tools Required
Wrench Set
Socket Set
SAE & Metric
Preparation Before Installation
1. Park your vehicle in a clean, level location. Check to make sure the vehicle is in park, or for
manual drive models, place the transmission in first gear. Engage the parking brake.
2. Chock one wheel on both sides with wheel chocks.
3. Unpack the bracket kit and identify the parts according to the content descriptions above.
Installation Instructions
Delta III Running Board
TM
• To be used with Lund branded products only.
• Do not stand on Lund running board or bracket while vehicle is in motion.
• Do not exceed 350 lbs. weight on the Lund EZ bracket system.
• Do not use the Lund EZ bracket system as a jacking point for vehicle.
• Do not use Lund EZ bracket system or running boards to fasten cargo.
• Periodically check all components for tightness.
• Be sure to wear safety glasses while installing Lund EZ bracket system.
• When using power tools read and understand all operating instructions.
M8
3/8-16 x 1
X16
Thread Cutter
X4
X8
End Cap
X2
1204
STD CAB
EXT CAB
CREW CAB X8
SAE & Metric
Silicone
1/4 x 5/8"
#14 x 3/4"
Square Head Bolt
Sheet Metal Screw
X20
X6
M8-1.25
U-NUT
X6
X4
X6
Wheel Chocks
1/8"
Page 1 of 6
EX-0156-07
10395
EX-0181-07
Rev A
EX-0194-07
1/4-20
X16
Splash Guard
X2
Safety Glasses
#2