Moni R8008 Instrucciones De Uso página 18

Step 1 – Installation of the side rails: Attach the side tubes to the backrest, as
shown in figures 1-1. The spring button must pop-up as shown in figure 1-3.
Step 2 – Installation of the rear tube: Place the side rails against the openings
of the rear tube. The buttons must align with the openings of the support tube.
While you press the spring buttons at the ends of the support, place the ends
in the respective openings of the fixing mechanisms of the side rails (see figure
2-1). Press carefully, until the tubes are fixed, when you hear a clicking sound
on both sides (see figure 2-2). Important: The support tube is constructed in
such a way that it can be placed in only one way. If while you assemble, you
see that is cannot be placed turn it and try again.
Step 3 - Placing of the toy bar: Attach the plastic hook to the side rails. Make
sure that the plastic hooks can be stopped in the front side of the black
washers (see figure 3). Place the board in the respective openings at the side
rails and press carefully until you hear a clicking sound, indicating that it is
fixed. After you place the toybar, make sure it is stable, then attach the toys to
it.
Step 4 - Adjustment of the position of the backrest:
Press the buttons on both sides of the backrest – press forwards or backwards
(see figure 4-1 and 4-2).
Upright position: Press the buttons at the sides of the rails and at the same
time raise the seat towards you.
Tilted position: While you press the buttons at the sides of the rail, tilt the
backrest backwards/downwards. Check the functionality of the legs of the
bouncer (see figure 4-3).
Step 5 – Placing of the safety belts: Unbutton the mechanism before placing
the baby. Place the baby and fasten the belts (you will hear a "click" sound
when properly fixed in the buckle). Fasten the belts around the child's waist in
a position that is comfortable for him. Check the restraint system by pulling it
slightly away from your child. The restraint system must remain attached.
INSTRUCTIONS FOR MAINTENANCE AND CLEANING
CLEANING
✓ The cover of the bouncer can be removed in order to be cleaned
better. Clean the upholstery of the product with a soft cloth soaked in warm
water and mild soap. After cleaning, allow the product to dry completely. Do
not use strong detergents, bleach or detergents with abrasive particles. It is
18