Connection Of The Ep801 System On The Rise To Etube Professional; Using The Sm-Pce02 Interface; Connection Of Assemblies With Sc-En600 Display And Mechanical Drivetrain; Connection Of Other Assembly Options - Orbea Blue Paper Rise Carbon 2023 Manual Tecnico

128 | ORBEA
31 CONNECTION OF THE EP801 SYSTEM ON THE RISE TO
ETUBE PROFESSIONAL USING THE SM-PCE02 INTERFACE
(INFORMATION FOR DEALERS)
Authorised dealers must perform the process of connect-
cycle, customise the system and perform certain types of
troubleshooting.
https://bike.shimano.com/en-EU/e-tube/project/forwin-
dows.html
al. It is also possible to connect and troubleshoot com-
tool manual:
TECHNICAL MANUAL
AVISO
Using the Shimano SM-PCE1 interface:
The system can also be connected to Etube
-
diagnostic tool.
-
Etube version 5 is not compatible with the
sions 4 and 5 from the Shimano website.
-
BLUE PAPER RISE CARBON · 20 2 3
CONNECTION OF ASSEMBLIES WITH THE SC-EN600 DISPLAY
AND MECHANICAL DRIVETRAIN
In the assembly option with the SC-EN600 and mechanical drivetrain (no Di2), you can connect the EW-SD300 standard
SW-EN600-L
to motor
CONNECTING OTHER ASSEMBLY
OPTIONS
-
· Assemblies with SC-EN600 display and Di2 electronic
drivetrain.
· Assemblies with no display and Di2 electronic drivetrain.
·Assemblies with no display and mechanical drivetrain
(non-Di2).
For these assembly options it is necessary to create a free
connection point to connect the entire system to the SM-
Shimano SM-PCE02
SC-EN600
Shimano EW-SD300
To do this, disconnect the Di2 SD300 cable from the SW-
port connector and an extra SD300 cable of any length to
create a free port in the system.
SW-EN600-L
extra EW-SD300
cable any length
junction
Shimano EW-SD300
ORBEA | 129
E N
Shimano SM-PCE02